Guides A-Z

This guide describes IECC 2009 and 2012 and ENERGY STAR Certified Homes insulation requirements.

This guide describes IECC 2015 and DOE Zero Energy Ready Home insulation requirements.

Guide describing the installation of insulating sheathing above the roof deck on existing homes. This retrofit assembly is appropriate for homes with conditioned attics or where the retrofit is intended to create a conditioned attic.

Guide describing how to insulate a basement to improve the overall thermal performance of the building and provide more dry, usable conditioned space for home occupants and HVAC equipment.

Guide describing how to air-seal attic access panels, doors, and stairs to provide a continuous air barrier at the ceiling.

Guide providing guidance on insulating attic eaves in new and existing single-family homes and multifamily buildings.

Guide describing how to insulate and air-seal attic knee walls and floor joist cavities under knee walls.

Guide describing application of a radiant barrier layer in the attic to block radiant heat transfer between hot surfaces and heat-absorbing surfaces.

Guide describing how to achieve RESNET Grade 1 installation standards, and meet/exceed code using batt insulation in existing walls.

Guide describing how to increase insulation in existing homes by installing batt insulation on the ceiling plane of a vented attic.

Guide describing how to add spray foam insulation to the underside of the existing roof deck as part of the conversion of a vented attic to an unvented, insulated attic.

Guide describing blown insulation into exterior wall cavities of existing homes with minimal disruption to occupants.

Guide describing how to insulate a vented attic in an existing home using blown insulation added to the attic floor.

Guide describing how to create a capillary break at all crawlspace floors using polyethylene sheeting to manage moisture in crawlspaces.

Guide describing continuous rigid insulation installation procedures to reduce thermal bridging and help provide thermal protection.

Guide describing how to insulate and air-seal dropped ceilings and soffits to prevent air leakage.

Guide describing buried ducts in loose-fill attic insulation, a method that can only be used in dry climates.

Guide describing approaches to burying and encapsulating ducts in unconditioned attics to increase the overall R-value of duct insulation.

Guide for designing and installing interior ducts in an interstitial floor cavity in new and existing homes.

Guide that illustrates how and when to encapsulate ductwork in unconditioned attics, increases the R-value of duct insulation, mitigating condensation issues and reducing air leakage.

Guide describing how to install slab edge insulation when retrofitting existing slab-on-grade foundations.

Guide describing how to insulate a new foundation wall or an existing foundation wall by adding rigid insulation to the exterior side.

Guide describing how to provide a continuous water control layer across the roof assembly by sealing all penetrations for pipes, vents, etc. in existing roofs.

Guide describing how to install and properly integrate flashing at the intersection of the wall and roof on an existing home.