Guides A-Z

This guide describes IECC 2009 and 2012 and ENERGY STAR Certified Homes insulation requirements.

This guide describes IECC 2015 and DOE Zero Energy Ready Home insulation requirements.

This measure guide describes the need to install a dedicated dual-pole circuit breaker for a future solar photovoltaic installation.

Guide describing the installation of insulating sheathing above the roof deck on existing homes. This retrofit assembly is appropriate for homes with conditioned attics or where the retrofit is intended to create a conditioned attic.

Guide describing the installation of boiler controls in multifamily housing.

Guide describing refrigerant-based compression-cooling air conditioning systems for space cooling.

Guide describing how to properly test the air barrier between the garage and house, and how to ensure the air barrier is tight enough to prevent garage air from entering the home.

Guide describing air-sealing of the seams and holes in HVAC air handler and furnace cabinets.

Guide describing how to insulate a basement to improve the overall thermal performance of the building and provide more dry, usable conditioned space for home occupants and HVAC equipment.

Guide describing how to air-seal and insulate a ceiling where the insulation is installed on top of the ceiling (on the attic floor) in a vented attic.

Guide describing ways to air-seal an attached garage in new and existing homes.

Guide describing how to air-seal attic access panels, doors, and stairs to provide a continuous air barrier at the ceiling.

Guide describing how to air-seal bathroom and kitchen exhaust fans.

Guide describing how to air-seal doors that are next to unconditioned spaces.

Guide describing ways to seal drywall to the top plate of an exterior wall to air-seal the wall cavity.

Guide describing how to air-seal duct and flue shafts.

Guide describing how to air-seal electrical wiring throughout a home.

Guide describing how to air-seal around light tubes.

Guide describing how to air-seal common walls between dwelling units in multifamily housing.

Guide describing how to air-seal around plumbing and piping penetrations through walls, ceilings, and floors.

Guide describing how to air-seal around recessed light fixtures below unconditioned space.

Guide describing how to air-seal sill plates in single-family homes and multifamily buildings.

Guide describing the repair and reconfiguration of the air handler closet and platform when replacing the air handler.

Guide describing how to air-seal the rough openings around doors and windows.

This measure guide describes basic steps for designing and installing an indirect (anti-freeze) solar hot water system.