Browse by Category | Building America Solution Center

Guide describing how to install transfer grilles in bedroom walls to balance air pressures between rooms and to enable stale air to return to a central heating system.

Information guide providing R-Values and vapor retarder classifications for common insulation materials.

Guide describing how to undercut the doors in bedroom walls to balance air pressures between rooms and to enable stale air to return to a central heating system.

Guide describing methods for insulating an unvented attic along the roof line.

Guide describing concerns with un-vented combustion appliances such as sealed fireplaces.

Guide describing a method for insulating an unvented attic by spraying foam insulation along the underside of the roof deck.

Guide describing construction of unvented, sloped, insulated roof assemblies in high wind zone areas.

Guide describing method for insulating an unvented crawlspace or conditioned basement with rigid foam on the interior side of the walls.

Guide describing the need to leave space for a solar hot water tank in the home’s utility room.

Guide describing replacement of a single-speed pool pump with variable-speed pump.

Guide describing options for insulating and air sealing at either the attic floor or along the roof line in new homes.

Information guide describing the need to ventilate a home before occupancy to reduce the concentration of VOC emissions in the home.

Guide describing how to install ventilation air inlets in open locations at a safe distance from potential air contamination sources.

Guide presenting central and individual dwelling unit ventilation and exhaust strategies for multifamily construction.

Guide describing condensing clothes dryers, which have a secondary heat exchanger and do not require exterior venting.

Guide describing how to install a radon-mitigating vertical ventilation pipe in new and existing homes with various types of house foundations.

Guide describing the design and installation considerations for recladding of above grade walls using insulated vinyl siding.

Guide describing how to construct the walls of a home with bracing to resist high wind and earthquake loads.

This guide describes how to install a rigid air barrier to separate the porch attic from the conditioned space.

This guide describes how to install a rigid air barrier to wall framing behind fireplaces.

This guide describes how to install a rigid air barrier to walls behind showers and tubs.

Guide describing how to elevate a water heater above the base flood elevation to protect it from flood damage.

Guide describing how to insulate the sill beam or sill plate on the exterior side in a way that allows drying to the exterior, as part of an exterior wall upgrade.

Guide describing an approach to re-roofing an existing flat roof to improve thermal, water, and air control performance.

Transfer Grilles

Typical R-values and Vapor Retarder Classifications for Common Insulation Materials

Undercut Doors

Unvented Attic Insulation

Unvented Combustion Appliances

Unvented Conditioned Attic with Spray Foam Insulation Below Roof Deck

Unvented Insulated Sloped Roofs

Unvented, Insulated Crawlspaces

Utility Room Space for Solar Thermal Systems

Variable-Speed Pool Pumps

Vented versus Unvented Attic

Ventilate Home Before Occupancy (Indoor AirPlus Requirement)

Ventilation Air Inlet Locations

Ventilation and Exhaust Strategies for Multifamily Housing

Ventless (Condensing) Clothes Dryers

Vertical Radon Ventilation Pipe

Vinyl Siding with Integrated Rigid Foam for Existing Walls

Wall Bracing for Hurricane, High Wind, and Seismic Resistance

Walls Adjoining Porch Roof

Walls Behind Fireplaces

Walls Behind Showers and Tubs

Water Heater Elevated and Secured

Water Managed Existing Sill Beams and Sill Plates

Water Managed Roof – Re-roofing and Adding Insulation over a Flat Roof

Filter