Browse by Category | Building America Solution Center

Guide describing removal of construction debris from flex ducts and protection of ducts and HVAC equipment during construction to keep them free of dust and debris.

Guide describing how to air seal and insulate fiber board ducts.

Guide describing how to air seal and insulate flex ducts.

Guide describing how to air seal and insulate metal ducts.

Guide describing how to air seal around duct shafts and flues installed through ceilings, walls, and flooring in new and existing homes.

Guide describing strategies for purging air in existing steam heating systems in multifamily buildings.

Guide describing how and where to install ducts, to ensure enough cavity space to avoid compression of the flex ducts or duct insulation.

Guide describing how to hang HVAC ducts with supporting straps or saddles to adequately support ducts so they do not sag and are not pinched or compressed.

Guide describing the use and testing of programmable thermostats.

Guide describing how to improve boiler efficiency in multifamily central hydronic heating systems by installing thermostatically controlled radiator valves (TRV) to reduce temperatures in overheated spaces.

Guide describing the split system heat pumps used for central forced air heating and cooling.

Guide describing how to install transfer grilles in bedroom walls to balance air pressures between rooms and to enable stale air to return to a central heating system.

Guide describing how to undercut the doors in bedroom walls to balance air pressures between rooms and to enable stale air to return to a central heating system.

Guide describing concerns with un-vented combustion appliances such as sealed fireplaces.

Guide describing how to install ventilation air inlets in open locations at a safe distance from potential air contamination sources.

Guide presenting central and individual dwelling unit ventilation and exhaust strategies for multifamily construction.

Guide describing how to select and install whole-house ventilation systems for existing homes.

Guide describing options for adding dehumidification equipment to a home to maintain indoor relative humidity below 60%.

Guide describing the types of whole-house fans, installation details to reduce air leakage, and ways to operate them for comfort and energy savings based on climate zone.

This guide describes how to install a whole-building ventilation system to provide adequate dilution of indoor air contaminants.

HVAC

Removing Construction Debris from Ducts

Sealed and Insulated Fiber Board Ducts

Sealed and Insulated Flex Ducts

Sealed and Insulated Metal Ducts

Sealing Duct Boots to Floor or Drywall

Steam System Balancing for Multifamily Existing Buildings

Sufficient Cavity Space for Flex Ducts

Support at Intervals for Flex Ducts

Thermostat Controls

Thermostatic Radiator Valves on Steam Heating Systems

Traditional Split Heat Pumps

Transfer Grilles

Undercut Doors

Unvented Combustion Appliances

Ventilation Air Inlet Locations

Ventilation and Exhaust Strategies for Multifamily Housing

Whole House Ventilation Strategies for Existing Homes

Whole-House Dehumidification

Whole-House Fans

Whole-House Ventilation Strategies for New Homes

Filter

HVAC