Showing results 4551 - 4600 of 4973
Image
Image
Image
Image
Image
Image
Wrong - Rigid insulation blocking is installed but not air-sealed with spray foam around edges.
Image
Image
Image
Wrong - Roof deck sheathing nails missed the trusses, potentially weakening the roof in high winds.
Image
Wrong - Roof is missing metal drip edge to cover the edge of OSB roof decking, roof underlayment should be trimmed back, and asphalt shingles are poorly installed.
Image
Image
Image
Wrong - Roof-wall juncture lacks metal flashing and is poorly designed, thus encouraging water entry.
Image
Image
Wrong - Roofs with complex geometries are more susceptible to ignition during a wildfire because they offer more places for burning embers to become lodged.
Image
Image
Image
Image
Image
Image
Image
Wrong - Self-adhered house wrap is poorly installed with many bubbles and gaps at seams.
Image
Wrong - Self-adhered house wrap is underlapped instead of overlapped which will allow rain water to get behind house wrap.
Image
Image
Image
Wrong - Step flashing is missing where the gable meets roof and the valley flashing is incorrectly on top of rather than under shingles.
Image
Wrong - Stucco has rotted and cracked above a window because of water damage due to lack of proper flashing and drainage.
Image
Image
Image
Image
Image
Image
Wrong - Tape is not well adhered to house wrap and wiring penetration is not sealed.
Image
Image
Wrong - The air barrier is not sealed (picture taken from garage looking into house).
Image
Wrong - The band joist above this garage-house shared wall is not properly sealed.
Image
Wrong - The basement blanket insulation is loosely attached to the interior of the basement wall, does not cover the entire wall, is not sealed at the edges, and is not installed over rigid foam that covers the entire surface of the foundation walls.
Image
Wrong - The below-grade concrete does not have the correct construction to be impermeable to moisture because the lumber is untreated and against the concrete that lacks waterproofing.
Image
Wrong - The caulk is too far from the sill plate to effectively air-seal the gap.
Image
Wrong - the CFM rating may not meet the performance specification once installed, and the sone rating is too high.
Image
Image
Wrong - The faced batt insulation does not provide an air barrier in the joist bay between the garage and the conditioned space of the home.
Image
Wrong - The fiberglass blanket insulation has no perforated vapor retarder, does not cover the entire basement wall, is not sealed at the edges, and is not installed over rigid foam.
Image
Image
Wrong - The furnace intake and exhaust are too close to each other and are missing rodent screening.
Image
Wrong - The furnace intake and exhaust are too close to each other and should be facing different directions.
Image
Wrong - The garage door sensor is too high and it should be 4 to 6 inches from the ground.
Image
Wrong - The ground of the crawlspace should be covered with a vapor barrier that extends up the sides of the crawlspace.
Image
Wrong - The gutter is missing kick-out flashing causing wall and window damage beneath it.
Image
