Showing results 1 - 50 of 59
Image
Image
A ground source heat pump with an open-loop piping system using vertical injection and recharge
Image
A ground-source heat pump has the same components as a standard air-to-air heat pump except that the liquid-to-refrigerant heat exchanger coil is located inside rather than outside
Image
A ground-source heat pump with a closed-loop horizontal “Slinky™ “piping arrangement
Image
A high-efficiency heat pump is installed in a closet within this home’s conditioned space.
Image
A single ductless heat pump heats and cools the country’s first DOE Zero Energy Ready certified manufactured home.
Image
Image
Image
By plotting the heating capacities at -4°F and 5°F and drawing a line between them, the capacity at 0°F can be estimated
Image
Cold-climate heat pumps can provide heating and cooling even in climate zone 7; this home retained a fuel oil boiler system for backup on the coldest days.
Image
Image
Image
Image
Ductless indoor units like this one are controlled individually by handheld remote controllers.
Image
Image
Image
Image
In heating mode, split system heat pumps absorb heat from the outside air and “pump” that heat to the indoor air handler unit, which releases it to the inside air.
Image
Right - The geothermal heat pump provides hot water for radiant floor heating, domestic hot water, and the air handler for space conditioning upstairs.
Image
Right - The home’s ground source heat pump preheats water for the air source heat pump water heater.
Image
Right - The home’s high-efficiency gas boiler provides domestic hot water as well as in-floor radiant heat, while a high-efficiency heat pump provides cooling and a secondary source of heating.
Image
Right - This ductless minisplit uses a ceiling-mounted rather than wall-mounted air handler.
Image
Right – Adequate space is provided near the air handler for the water lines of this ground-source heat pump.
Image
Right – An air-to-water heat pump efficiently provides hot water for radiant floor heating.
Image
Right – An air-to-water heat pump provides water and space heating while a heat recovery ventilator provides fresh air that is filtered by the HEPA filter.
Image
Right – The double compressor unit supplies multiple interior minisplit heat pump heads.
Image
Right – The ductless minisplit in this open area is installed in the ceiling rather than on a wall.
Image
Right (decent): For a relatively high-capacity ccASHP sized per Approach 3 or 4 to meet nearly 100% of the heating load, this heat pump’s modulating zone has a decent overlap with the home’s heating load line, reducing short-cycling.
Image
Right: Sized per Approach 1, this heat pump will have minimal short-cycling; since sized using Approach 1, it will require backup heat when temp is below 30°F but could still contribute significant heating down to heating design temp (-6°F) and lower
Image
Right: Sized per Approach 3 or 4, this heat pump’s modulating zone has a large overlap with the home’s heating load line, resulting in minimal short-cycling; the unit may require a small amount of backup heat during the very coldest hours of winter.
Image
Right: Sized per Approach 3, this heat pump’s modulating zone has a large overlap with the home’s heating load line; it will require backup heating but could still contribute significant heating for all hours of the heating season
Image
Image
The ductless air handler of a ductless heat pump can be mounted above the ceiling so that only the register is visible
Image
The high-efficiency air-to-air heat pump is set in an overflow pan with an emergency shut off sensor in case the condensate tube were to clog and cause condensate to fill up the pan.
Image
The high-efficiency mini-split heat pump provides cooling and heating; a drain pipe carries condensate away to a location that meets local code requirements.
Image
The NEEP Cold Climate Air Source Heat Pump List allows users to search, sort, and filter for cold climate heat pumps by brand, model, product type, and ducting configuration; an advanced search provides helpful resources for sizing to the heating load
Image
The ultra-efficient air-to-water heat pump draws heat from the outside air to heat inside room air in winter and domestic hot water year-round.
Image
These plots compare sizing approaches in terms of the approximate annual heating load a heat pump might carry throughout the year for a hypothetical home in Minneapolis, MN.
Image
This “high static ducted cassette” heat pump system is similar to a traditional centrally ducted system, serving several areas of a home from one indoor unit
Image
This cold-climate heat pump can meet >90% of this home’s heating needs, even in Cordova, Alaska.
Image
This cold-climate heat pump provides heat at 77% capacity at 5°F, and 57% of capacity at -5 °F.
Image
This cold-climate heat pump provides heating and cooling for a home in Cordova, Alaska.
Image
This home’s ultra-efficient ground-source heat pump provides hot water for space heating as well as domestic hot water for the 50-gallon storage tank.
Image
This multi-split heat pump system incorporates several indoor units connected to just one outdoor unit; the indoor units include a wall-mounted unit, floor-mounted, ceiling cassette, and mini-air handler.
Image
This plot shows a heat pump’s minimum and maximum cooling capacities overlaid with a home’s cooling load line, allowing a designer to assess how well-suited the equipment is for the specific home.
Image
This plot shows a heat pump’s minimum and maximum heating capacities overlaid with a home’s heating load line as well as the annual heating load hours for the home, allowing a designer to assess how well-suited the equipment is for the specific home.
Image
This plot shows a heat pump’s minimum and maximum heating capacities overlaid with a home’s heating load line, allowing a designer to assess how well-suited the equipment is for the specific home.
Image
This plot shows a heat pump’s minimum and maximum heating capacities overlaid with a home’s heating load line, allowing a designer to assess how well-suited the equipment is for the specific home.
Image
This single-zone mini-split ductless heat pump has only one indoor wall-mounted unit and one outdoor unit.
Image
This traditional centrally ducted heat pump heats and cools the entire home through a network of ducts.