Showing results 1 - 17 of 17
Image
A piece of siding is used as sill extension and to provide slope in the opening for the window, which is deeper because exterior rigid foam has been added
Image
Expanded polystyrene insulation is installed with joints taped and lath attached in preparation for the application of stucco
Image
Flashing is installed above the foundation wall before installing the siding. Seams in sheathing are sealed with tape and caulk, while nail holes are sealed with caulk.
Image
Holes in the exterior walls are flashed and flashing is integrated with housewrap before installing rigid mineral wool insulation.
Image
Integrate pre-formed vent pipe flashing, shingle-fashion, with roofing underlayment and shingles
Image
Missing step flashing and kickout flashing caused rotting of wall and roof sheathing, fascia, framing, and plywood cover below the eave at this complicated roof juncture.
Image
Proper flashing around windows is especially important when the rigid foam serves as the drainage plane in the wall
Image
Image
Right - Seams in coated sheathing and joints around window are properly sealed and flashed with tape and all nail holes are covered with paint-on sealant.
Image
Image
Image
Spray foam adhesive provides an extra water resistant layer to the joints and seams on the inside of attics.
Image
The home is sheathed with rigid foam insulation and all seams and holes are taped to provide a continuous air barrier.
Image
The retrofitted flat roof has PV panels and walking mats installed over the roofing membrane
Image
This farmhouse was retrofit by removing the existing siding and adding taped insulated sheathing and battens before installing new siding
Image
Two types of paint-on flashing (green and red) are installed on the walls and around the windows, over the coated sheathing which is taped at the seams.
Image
Wrong – The flashing of the roof-wall juncture was installed above the roof shingles instead of below the roof shingles; also no kickout flashing was installed.