Library

Article describing vapor retarder requirements in the International Residential Code and International Building Code 2021.

Article describing thermal bridging, construction practices that encourage thermal bridging, and solutions.

Guide for homeowners describing how to find and seal basement and attic air leaks, determine if attic insulation is adequate, make improvements safely, and reduce energy bills.

Report describing testing and analysis on deep energy retrofits of existing single-family homes in the U.S.

Article describing methods for thermally isolating a garage in a Passive House-certified multifamily building.

Technical report describing the SPS (Structural Panel System), an innovative implementation of the "perfect wall" concept, situating environmental control layers on the exterior side of structural components for improved constructability, cost-effectiveness, and performance, validated through the...

Website article interviewing the inventor of the Larsen truss, a history of its use, and a discussion of its advantages and disadvantages.

Article about different types of weather resistant barrier.

Technical report describing the thermal performance of 40 common building envelope details for mid- and high-rise buildings, including analyses to optimize energy efficiency and reduce thermal bridging.

Article by the Canadian Government on attic ventilation and considerations for moisture and ice dams.

Report covering interior energy retrofits of masonry buildings.

Article describing the building science implications of insulating vented or unvented attics.

Article describing the research into insulating vented versus unvented attics.

SPFA website signup page to access SPFA documents.

Report describing approaches to insulating basements in homes built to meet Energy Star levels of performance of heat loss reduction.

Information sheet describing techniques for insulating basements.

Document focusing on the design and wall components that contribute to a pressure equalized rain screen wall, including the frequency of the weep holes and other brick masonry rain screen wall requirements.

A book about structurally insulated panels.

Web based tool providing decision-making guidance for selecting wall assembly components.

Article describing the control layers (air, thermal, and vapor barriers) needed to build homes successfully in very cold locations.

Article describing correct ways to eliminate water damage by incorporating a sacrificial layer to foundation walls and footings.

Article describing the principle of capillarity in construction materials.

Website of the Cold Climate Housing Research Center.

Information sheet with information about insulating and ventilating attics.

Case study characterizing the framing factors for the exterior walls, ceilings, and floors of 180 wood-framed low-rise residential buildings across the United States.

Article describing how closed crawlspaces can do "double duty" by controlling moisture and providing energy savings.

Information guide describing issues with concrete floors, in multiple climate zones.

Report covering insulating crawlspaces.

Guidance from Zero Energy Project on construction techniques for warmer climates, such as home orientation, and insulation requirements.

Article about how mortar droppings during the installation of a brick veneer can clog the weep holes in the wall assembly causing moisture damage. The article also illustrates products that can be installed in the ventilated cavity to mitigate this problem.

Article describing research encouraging use of exterior insulation to warm interior sheathing surfaces in walls and roof assemblies to reduce the likelihood of condensation during cold weather

Article describing the difference between conditioned or unvented attics and unconditioned or vented attics.

Article discussing whether or not to seal and insulate crawlspaces.

Article describing the importance of air sealing, insulation, and roof ventilation in reducing the likelihood of ice dam formation on roofs in cold snowy climates.

Report covering exterior energy retrofits of masonry buildings.

Guide informing architects and engineers about designing buildings to be constructed with structural insulated panels.

Information about dense pack, cellulose insulation.

Information sheet with HVAC duct insulation, testing, maintenance and performance information.

Webpage from U.S. Department of Energy describing using Earth-Sheltered home building techniques in hot climate zones.

Report on problems and solutions with EIFS stucco wall cladding systems.

Website describing the U.S. Environmental Protection Agency's ENERGY STAR New Homes and Apartments program with links to builder and homeowner resources.

Homebuilding’s simple payback estimator for an insulation upgrade – the type and amount of insulation, square footage of the area, recent utility bill, and a quote from insulation contractor.

Information sheet briefly summarizing double stud with spray foam wall construction including the advantages and disadvantages of this construction strategy.

Information sheet that summarizes Insulated Concrete Form (ICF) construction including advantages and disadvantages of this construction strategy.

Report that demonstrates the durability, constructability, and cost-effectiveness of the extended plate and beam (EP&B) wall system for new construction housing projects in compliance with the International Energy Conservation Code, addressing moisture risk management and high-performance envelope...

Article from Building Science Corporation on construction techniques for extreme heat conditions in Dubai and Las Vegas.

Article describing five fundamental changes to building construction from the last 50 years and their modern construction consequences.

Article discussing flow-through assemblies of walls.

Journal article describing lessons learned from updating a 16-year-old deep-energy retrofit.

Article describing the effective R-values of various subslab insulation products, including foil bubble pack.