Showing results 1 - 19 of 19
Image
A piece of siding is used as sill extension and to provide slope in the opening for the window, which is deeper because exterior rigid foam has been added
Image
Blocking installed on a flat roof for a PV system rack is sealed around the edges with sealant then will be covered with self-adhering roof membrane to prevent water leakage
Image
Plan view of duct or pipe penetration through exterior wall showing flashing and air sealing details
Image
Plan view of electric box installation in exterior wall showing flashing and air sealing details
Image
Polyisocyanurate rigid foam insulation is installed in multiple layers with staggered, taped seams over the flat roof
Image
Right - Corners of window are protected with draining house wrap that laps onto the sides of the window trim, paint-on flashing at window trim corners, and self-adhered flashing to reinforce corners.
Image
Right - Here, air control is established by taping the seams of the plywood panel sheathing. The roof sheathing is also trimmed flush with the wall sheathing to allow a simple and airtight connection between the roof and wall assemblies
Image
Right - Permeable rigid mineral wool insulation and appropriate water-management flashing details are integrated with new rigid foam siding to keep water away from the sill beam above the foundation wall
Image
Right - The pipe penetration is properly flashed and furring strips are installed on each side in preparation for installing cladding
Image
Image
Right - The water and air control layers are properly integrated around the hose bib
Image
Right - This duct penetration is properly flashed and integrated with the taped, foil-faced foam sheathing layer, which serves as the air and water barrier
Image
Right – Even house wrap is installed in the factory for these modular homes where each floor is factory assembled.
Image
Right – The base of the wall is water proofed and the seam between the base of the wall and the sidewalk is air sealed.
Image
Right – This low-slope flat roof assembly has continuity of both the air and water barriers
Image
Right – This low-slope roof and parapet assembly has continuity of both the air and water barriers
Image
Section view of duct or pipe penetration through exterior wall showing flashing and air sealing details
Image
Section view of electric box installation in exterior wall showing flashing and air sealing details
Image
This exterior wall retrofit permits drying to the exterior of a sill plate installed on an untreated flat foundation wall