Showing results 1 - 13 of 13
Image
A piece of siding is used as sill extension and to provide slope in the opening for the window, which is deeper because exterior rigid foam has been added
Image
Plan view of duct or pipe penetration through exterior wall showing flashing and air sealing details
Image
Plan view of electric box installation in exterior wall showing flashing and air sealing details
Image
Right - Corners of window are protected with draining house wrap that laps onto the sides of the window trim, paint-on flashing at window trim corners, and self-adhered flashing to reinforce corners.
Image
Right - Permeable rigid mineral wool insulation and appropriate water-management flashing details are integrated with new rigid foam siding to keep water away from the sill beam above the foundation wall
Image
Right - The pipe penetration is properly flashed and furring strips are installed on each side in preparation for installing cladding
Image
Image
Right - The water and air control layers are properly integrated around the hose bib
Image
Right - This duct penetration is properly flashed and integrated with the taped, foil-faced foam sheathing layer, which serves as the air and water barrier
Image
Right – The base of the wall is water proofed and the seam between the base of the wall and the sidewalk is air sealed.
Image
Section view of duct or pipe penetration through exterior wall showing flashing and air sealing details
Image
Section view of electric box installation in exterior wall showing flashing and air sealing details
Image
This exterior wall retrofit permits drying to the exterior of a sill plate installed on an untreated flat foundation wall