Showing results 1 - 23 of 23
Image
Image
A structural spline made of a solid 2x is used where needed to meet structural load requirements at SIP panel seams
Image
A surface spline reduces thermal bridging much more than a structural spline at SIP panel seams
Image
Image
An all-terrain forklift is used to move and stage the panels
Image
An insulated spline is another option for avoiding thermal bridging at SIP panel seams
Image
Construct exterior walls with structural insulated panels (SIPs) to provide an airtight wall with consistent insulation and very little thermal bridging.
Image
Install a housewrap drainage plane between the SIP panels and the exterior cladding
Image
Insulated splines consisting of boards layered with rigid foam minimize energy loss at joints between the SIP wall panels.
Image
Lifting plates attached to the wall provide good bracing to tighten up SIP panel seams
Image
Make sure the beads of caulk are continuous the full length at each SIP panel seam, such as at the wall-roof seam, to maintain air barrier continuity
Image
Peel-and-stick panel tape provides added assurance that SIP panel seams will remain airtight
Image
Right – SIP panels assemble quickly on site to provide sturdy walls and a roof that needs few interior supports so there is great flexibility in the layout of interior spaces.
Image
SIP panel walls are less susceptible to air leakage and convection issues than stick-built walls
Image
SIP panels should be stacked high, dry, and flat
Image
Structural insulated panels offer a continuous layer of thermal protection and draft resistance around the home and come from the factory precut for fast assembly.
Image
Structural insulated panels provide a continuous layer of insulation sandwiched between two continuous layers of OSB for thermal protection and sturdy construction.
Image
The back dam of the window sill will force water out
Image
This foundation/floor/SIP wall detail shows recommended support of SIP wall panel at the sill plate
Image
This technique for installing electrical wiring avoids the need to cut into the SIP panel
Image
Two layers of high-permeability house wrap are installed to provide a drainage layer between the SIPS and the homes external cladding
Image
Use a smoke pencil to check for air leaks at SIP panel seams, especially along the ridge beam
Image
Walls are being assembled at this SIP house