Showing results 1 - 22 of 22
Image
Image
Image
Image
Durability concerns on a house continuously sheathed with a proprietary fiber structural panel used as bracing. Photo 1 of 2.
Image
Durability concerns on a house continuously sheathed with a proprietary fiber structural panel used as bracing. Photo 2 of 2.
Image
End conditions for braced wall lines with continuous sheathing, Figure R602.10.7 in the IRC
Image
Improper continuous load path design lacking bracing results in the failure of gable end walls under high wind conditions.
Image
Image
Image
Image
Right - A continuous load path connects the roof and wall framing to the foundation.
Image
Right - Braced wall line spacing is correctly calculated for determining wall bracing in accordance with the IRC.
Image
Image
Step 1. Remove the existing wall cladding to prepare to retrofit an exterior wall.
Image
Step 2. Install a continuous air and water control layer over the existing wall sheathing.
Image
Step 4. Install insulating sheathing and vertical furring strips on the retrofitted exterior wall; seal around pipe or duct with urethane sealant.
Image
Step 5. Install sheathing tape flashing over the duct or pipe and wood blocking on either side for later attachment of trim.
Image
Step 6. Install vent hood trim block, metal cap flashing; seal top edge of flashing with sheathing tape.
Image
Image
Step 8. Attach the new cladding to the furring strips over the rigid foam for the exterior wall retrofit.
Image
Image
Upper-floor tie to lower floor for two-story building. Floor tie anchor and nailed wall sheathing.