Showing results 1 - 19 of 19
Image
All ceiling, wall, floor, and slab insulation shall achieve RESNET-defined Grade I installation
Image
Batt insulation should be cut to fit around wiring so that insulation can completely fill the wall cavity
Image
Blown cellulose insulation completely fills the netted wall and ceiling cavities.
Image
Image
Ceiling, wall, floor, and slab insulation levels shall meet or exceed Builders Challenge levels
Image
Faced fiberglass batt insulation can be stapled to the stud faces or slightly inset, but avoid compressing the batts
Image
Image
Image
Image
Right - Rigid foam slab edge insulation is installed along the exterior edge of a monolithic slab foundation.
Image
Image
Image
Rigid foam forms an insulating bond break between the foundation wall and the slab
Image
Spray foam insulation is installed in open wall cavities to air seal and insulate
Image
Unfaced fiberglass batt insulation is installed to completely fill the wall cavities and is sliced to fit around wiring, piping, and other obstructions in the wall cavities
Image
Wrong – Compression and misalignment because insulation is not split around plumbing
Image
Wrong – Compression and misalignment because insulation is not split around wires
Image
Image
