Showing results 551 - 578 of 578
Image
Image
Wrong - The seam around the duct boot where the duct boot enters the trunk duct has not been completely sealed with mesh tape and mastic.
Image
Wrong - The support strap for the duct is too tight and the radius of the turn is too sharp.
Image
Image
Image
Wrong - Two exhaust terminations are joined in a roughly cut, restrictive hole that is not air sealed.
Image
Wrong - Vent screening on outdoor air intake has been clogged with dirt and screen has been pulled up into vent and is no longer covering the entire opening.
Image
Wrong -The duct does not have enough support so it is sagging and compressing the duct
Image
Wrong – Duct is pulling away from ceiling because it is not sealed to the ceiling
Image
Image
Image
Image
Image
Wrong – The HVAC compressor was not adequately secured to an elevated platform and was washed away.
Image
Wrong – These flex ducts are pulled taut, which is correct but they are inadequately supported with straps that are spaced too far apart and are too tight causing pinching of the insulation and turns are sharp rather than gradual.
Image
Wrong – Two combustion appliances are sharing a flue which could lead to backdrafting if one appliance is updated to a direct vent appliance and disconnected from shared chimney.
Image
Wrong- A tie strap should not be used over the duct outer liner because it can compress the insulation. Tuck in the fibrous insulation and seal the outer liner to the connecting duct with mastic or foil tape (Steven Winter Associates 2013).
Image
Wrong: Open wall cavities in the un-air-sealed return plenum connect the plenum to attic spaces
Image
Wrong: open wall cavity connected to this return air plenum is allowing cellulose attic insulation to be pulled into the furnace
Image
Wrong: Sized per Approach 1 or 2, this heat pump’s modulating zone has a small overlap with the home’s heating load line, resulting in a large amount of short-cycling; the unit will require backup heat when the temperature is below 25°F
Image
Wrong: Sized per Approach 3, there is minimal overlap between this heat pump’s modulating zone and the home’s heating load line, causing excessive short-cycling; it will require backup heat and may not contribute significantly at temperatures below 5°F
Image
Wrong: Sized per Approach 3, there is small overlap between this heat pump’s modulating zone and the home’s heating load line, resulting in excessive short-cycling; it will require backup heat when the temperature is below 5°F
Image
Wrong: The door and filter were removed, allowing unfiltered air to enter the air handler leading to premature failure of the system due to dirt accumulation.
Image
Wrong: The return plenum is not air sealed to separate it from the wall cavities and it should not be used for storage
Image
Wrong: This air handling equipment is installed in the garage without isolating the equipment from the garage space
Image
Wrong: This heat pump is oversized even for Approach 4, and its modulating zone has a small overlap with the home’s heating load line, resulting in a large amount of short-cycling.
Image
Wrong: This return air plenum is not lined and air sealed
Image
Wrong: This wall cavity is open to the attic allowing unconditioned, attic air to enter the HVAC system, bypassing the filter, and degrading system life and performance