Showing results 1 - 8 of 8
Image
Plan view (from above) showing how the existing garage wall gypsum board is cut away to air-seal the shared wall before adding rigid foam insulation on the garage and exterior walls of the home.
Image
Right – Spray foam insulates the walls and ceilings separating the garage from the home.
Image
Rigid foam insulation is installed on the garage side of the shared garage wall and roof of an existing home
Image
Side view showing air-sealing and rigid foam insulation is installed over existing wall and ceiling under a room above, then covered with new gypsum board.
Image
Side view showing how the existing garage wall and ceiling are air-sealed prior to installing rigid foam insulation on the garage side of the shared wall of an existing home.
Image
This hot climate zone home uses high quality batt insulation between studs to insulate this connecting garage wall.
Image
To ensure a complete air barrier between the garage and the house, the wall between the garage and the house was insulated and air-sealed with four inches of high-density spray foam.
Image
