Showing results 151 - 200 of 422
Image
Image
Image
Image
Image
Image
Image
Image
Image
Image
Image
Open floor trusses used as return air plenums can draw air from any place connected to that floor
Image
Open-web floor joists provide space for ducts between the floors of a two-story home.
Image
Packing tape has been removed and damper will be able to function properly once fan is installed
Image
Pan stock is used to form a boot for future register installation
Image
Plan view of duct or pipe penetration through exterior wall showing flashing and air sealing details
Image
Prepare chase with adhesive for bottom insulation
Image
Prescriptive Path: Supply ducts in unconditioned attic have insulation ≥ R-8. Performance Path: Supply ducts in unconditioned attic have insulation ≥ R-6
Image
Image
Pull the insulation and outer liner of the flex duct over the collar to come in full contact with the liner and insulation of the trunk line or fitting and tape in place
Image
Pulling flex duct taut when installing greatly reduces the amount of friction caused by the ducting
Image
R-6 flexible duct has 2 inches of insulation around the inner liner so a 12-inch duct requires a 16x16-inch chase
Image
Raised ceiling chase sealed with drywall mud
Image
Raised ceiling duct chase is not visible as finished product
Image
Rater-measured duct leakage to outdoors ≤ 4 CFM25 per 100 sq. ft. of conditioned floor area
Image
Image
Image
Image
Image
Image
Right - a dropped ceiling below a taped plywood air barrier provides a service cavity for ducts and wiring.
Image
Right - A heat recovery ventilator supplies all living spaces with fresh air while transferring heat for energy savings.
Image
Right - A high-efficiency (95 AFUE) wall-hung gas-fired boiler heats water for the hydro-coil space heating system and also provides a back-up for the solar hot water system.
Image
Right - All seams in the HVAC equipment and ductwork are sealed with mastic; because the HVAC equipment is in the garage, it is an air-sealed closet.
Image
Right - An in-line air flow testing station is installed in a straight section of smooth metal duct (red outline) to determine the air flow rate of a fresh air intake for a whole house ventilation system.
Image
Right - An ultra-efficient (COP 5.7) ground source heat pump provides hot water to an air coil in the central air handler which uses a variable-speed electrically commutated fan motor to distribute conditioned air to the home’s ducts.
Image
Right - Drywall was installed before installing the duct chase to ensure the ducts will be separated from the attic.
Image
Image
Right - Flex duct installed with adequate support and pulled taut to provide adequate air flow
Image
Right - Flex duct installed with frequent supports, straight runs, and gradual turns to allow good air flow
Image
Right - HVAC ducts should be well-supported with minimal bends and pinching.
Image
Right - Open-cell polyurethane spray foam to R-28 on underside of roof turns new attic into conditioned space for HVAC.
Image
Image
Image
Right - Straps are spaced close enough together to provide adequate support of the flex duct
Image
Right - The butterfly damper of this crawlspace supply register opens when the HVAC fan is running; the damper duct is sealed with mastic and supported by strapping.
Image
Right - The duct shows redundant sealing including the caulk, tape, and flashing
Image
Image
Right - The HVAC ducts are located in conditioned space in a dropped hallway ceiling with very short duct runs for more efficient delivery.
Image
Right - The kitchen exhaust duct termination is integrated aesthetically and functionally with the exterior cladding; however, the opening should be screened to keep out pests.
Image
