Library

Webpage describing steps homeowners can take to prepare their home and car for winter storms.

Webpage providing guidance for homeowners on how much snow weight a typical roof can handle and when to consider removing snow from the roof.

Report providing wildfire protection guidance for homeowners in California.

Fact sheet describing the special considerations that must be made when installing utility equipment, such as fuel, sewage, and water/sewage lines in a coastal home, and presenting recommendations for utility protection; also published in FEMA P-499 “Home Builder’s Guide to Coastal Construction...

Technical fact sheet describing the selection and installation of storm shutters and impact-resistant glazing and other types of opening protection in windborne debris regions; also published in FEMA P-499 “Home Builder’s Guide to Coastal Construction: Technical Fact Sheet Series.”

An example of a form a building codes department created to ensure builders are fully aware and have taken steps to provide drainage so that water doesn’t accumulate behind siding. This example is from the city of Newberg, Oregon.

Report describing methods for reducing the cost of electric vehicle charging infrastructure.

Information sheet describing refrigerant line installation and system startup procedures.

Fact sheet describing an alternative to piles in V Zones and A Zones in coastal areas where soil properties preclude pile installation, but the need for an “open foundation system” still exists and recommendations for good masonry practices in coastal environments; also published in FEMA P-499 “Home...

Fact sheet describing NFIP requirements for repairs, remodeling, and additions, and discussing opportunities for retrofitting in coastal flood hazard areas with recommendations for exceeding the minimum NFIP requirements; also published in FEMA P-499 “Home Builder’s Guide to Coastal Construction...

Fact sheet describing requirements and opportunities for retrofitting, and making “best practice” recommendations for repairs, remodeling, and additions in coastal high wind areas; also published in FEMA P-499 “Home Builder’s Guide to Coastal Construction: Technical Fact Sheet Series.”

Presentation providing information about correctly installing ductwork in new and existing homes.

Report identifying efficient, connected, smart, and flexible GEB technologies and their future potential, including barriers and opportunities, recommendations for policymakers, and research needs.

Paper covering a parametric study of foundation heat exchanger-based ground source heat pump systems for several house configurations in a range of European locations, with an emphasis on determining feasible combinations.

A student manual for containing information on residential sprinkler systems.

Report describing the costs, benefits, and challenges of attic insulation retrofits in HUD-code manufactured homes.

Report identifying the steps to take, with the help of a qualified home performance contractor, to seal unwanted air leaks while ensuring healthy levels of ventilation and avoiding sources of indoor air pollution.

Report about a tool developed to enable users to compare a typical 1970s ranch home against an IECC 2009 code-compliant home of the same configuration and against the 70s base case plus retrofits.

Information sheet about insulation retrofits for the hot-dry climate zones.

Information sheet about exterior insulation in the hot-dry climate zones.

Information sheet about HVAC equipment design to maximize energy efficiency in the hot-dry climate zone.

Information sheet describing solar PV upgrade for an existing homes.

Information sheet describing tankless hot water heating systems in existing homes.

Information sheet describing solar hot water systems in existing homes.

Information about a roof retrofit using a metal, cool roof system.

Information sheet describing tankless hot water heating systems in existing homes.

Information sheet about envelope and roof moisture control retrofit for a home.

Information sheet about window retrofit strategies for hot-dry climates.

Fact sheet describing proper roof sheathing installation and illustrating fastening methods that will enhance the durability of a building in high-wind areas; also published in FEMA P-499 “Home Builder’s Guide to Coastal Construction: Technical Fact Sheet Series.”

Fact sheet describing recommended practices for the use of roofing underlayment as an enhanced secondary water barrier in coastal environments and optional installation methods; also published in FEMA P-499 “Home Builder’s Guide to Coastal Construction: Technical Fact Sheet Series.”

Fact sheet describing the importance of proper roof and deck flashing, and typical and enhanced flashing techniques for coastal homes; also published in FEMA P-499 “Home Builder’s Guide to Coastal Construction: Technical Fact Sheet Series.”

Article describing how insulating and air sealing unfinished attic spaces can lead to reduced energy bills in some homes.

Fact sheet describing guidance concerning lot selection and building siting considerations for coastal residential buildings, including factors that constrain siting decisions, coastal setback lines, common siting problems, and suggestions for builders, designers, and owners; also published in FEMA...

Report comparing the performance of seven differing types of residential water heating systems in a side-by-side test configuration over a full year period.

Fact sheet describing basic design and installation tips for various types of siding for high-wind regions, including vinyl, wood, and fiber cement and discusses sustainable design issues; also published in FEMA P-499 “Home Builder’s Guide to Coastal Construction: Technical Fact Sheet Series.”

Webpage describing the basics of solar plus storage operations on homes.

California Energy Commission report presenting the concept of cool walls and providing guidelines for their building- and climate-appropriate use to conserve energy and reduce emissions.

Standard that defines the roles of and minimum requirements for mechanical and natural ventilation systems and the building envelope intended to provide acceptable indoor air quality in low-rise residential buildings; published in the year 2019, and is available for preview and purchase at the...

ASTM designation regarding two radon control options for low-rise residential building construction. This standard was produced in the year 2008, and is available for preview and purchase at the reference link.

Detailed requirements for testing, exposure modeling, and allowable limits for modeled indoor air concentrations.

Standard that covers the minimum performance and acceptance criteria for an air barrier (AB) material or system for framed walls of low-rise buildings with the service life of the building wall in mind. This link directs to a preview of the current version of the standard, published in the year 2019...

Specification describing criteria for manufactured polymeric materials used to provide a rainscreen function, a means for the drainage of liquid moisture and the ventilation of vapor moisture that enters an above-grade exterior wall assembly which was published in the year 2019, and is available for...

This standard specification covers the classification, composition, physical properties, and dimensions of mineral fiber (rock, slag, or glass) blanket intended for use as thermal insulation on surfaces at various temperature ranges. This version of the standard was published in the year 2019 and is...

Standard describing a test method measuring air-leakage rates through a building envelope under controlled pressurization and de-pressurization which was published in the year 2019 and is available for preview and purchase at the reference link.

Standard that describes the principles for the design of a hot box apparatus and the minimum requirements for the determination of steady state thermal performance of building assemblies when exposed to controlled laboratory conditions. The current version of the standard was published in 2019, and...

Discussion of building sheathing.

Recovery advisory presenting key wind retrofit guidelines for buildings located in hurricane-prone regions. These retrofit guidelines are intended to help building owners and designers prevent or limit wind damage and water infiltration during high-wind events.

Fact sheet describing recommendations for exceeding NFIP regulatory requirements for new construction and for repairs, remodeling, and additions, including building foundations, enclosures below the Base Flood Elevation (BFE), use of nonstructural fill, use of space below the BFE, utilities...

Presentation by the Washington University in St. Louis Office of Sustainability on saving energy.

The Technician's Guide equips practitioners with the knowledge to properly implement all of the measurement procedures required in the HVAC QI Specification.