Library

Fact sheet describing basic information about pile design and installation, including pile types, sizes and lengths, layout, installation methods, bracing, field cutting, connections, and verifying capacities; also published in FEMA P-499 “Home Builder’s Guide to Coastal Construction: Technical Fact...

Report briefly reviewing past research on the effects of occupant behavior on residential energy use and then covering a two year pilot evaluation of a low cost residential energy feedback system installed in twenty case study homes in Florida.

Document with information about the most practical methods to achieve whole-wall performance of R-30 or above.

Article describing how ice dams form on residential roofs, how they damage homes, and solutions to prevent future dams.

Fact sheet describing the special considerations that must be made when installing utility equipment, such as fuel, sewage, and water/sewage lines in a coastal home, and presenting recommendations for utility protection; also published in FEMA P-499 “Home Builder’s Guide to Coastal Construction...

Technical fact sheet describing the selection and installation of storm shutters and impact-resistant glazing and other types of opening protection in windborne debris regions; also published in FEMA P-499 “Home Builder’s Guide to Coastal Construction: Technical Fact Sheet Series.”

Website providing an online calculator for determining energy and cost savings from installing radiant barriers in attics.

An example of a form a building codes department created to ensure builders are fully aware and have taken steps to provide drainage so that water doesn’t accumulate behind siding. This example is from the city of Newberg, Oregon.

Information sheet with the definition and uses for a raised truss.

Illustrations of range tip-over outcomes with and without door locking mechanism.

Research study about two test homes that are examined with the goal of providing case studies that could be applied to other similar New England homes.

Information sheet describing refrigerant line installation and system startup procedures.

Fact sheet describing an alternative to piles in V Zones and A Zones in coastal areas where soil properties preclude pile installation, but the need for an “open foundation system” still exists and recommendations for good masonry practices in coastal environments; also published in FEMA P-499 “Home...

The RERH specifications and checklists take a builder and a project design team through the steps of assessing a home’s solar resource potential and defining the minimum structural and system components needed to support a solar energy system.

Fact sheet describing NFIP requirements for repairs, remodeling, and additions, and discussing opportunities for retrofitting in coastal flood hazard areas with recommendations for exceeding the minimum NFIP requirements; also published in FEMA P-499 “Home Builder’s Guide to Coastal Construction...

Fact sheet describing requirements and opportunities for retrofitting, and making “best practice” recommendations for repairs, remodeling, and additions in coastal high wind areas; also published in FEMA P-499 “Home Builder’s Guide to Coastal Construction: Technical Fact Sheet Series.”

Webpage containing downloadable fact sheets covering carpet-related topics including Indoor Air Quality, Asthma and Allergy, Cleaning Products, and Environmental Sustainability.

Presentation providing information about correctly installing ductwork in new and existing homes.

Paper covering a parametric study of foundation heat exchanger-based ground source heat pump systems for several house configurations in a range of European locations, with an emphasis on determining feasible combinations.

Report identifying the steps to take, with the help of a qualified home performance contractor, to seal unwanted air leaks while ensuring healthy levels of ventilation and avoiding sources of indoor air pollution.

Report about a tool developed to enable users to compare a typical 1970s ranch home against an IECC 2009 code-compliant home of the same configuration and against the 70s base case plus retrofits.

Information sheet about insulation retrofits for the hot-dry climate zones.

Information sheet about exterior insulation in the hot-dry climate zones.

Information sheet about HVAC equipment design to maximize energy efficiency in the hot-dry climate zone.

Information sheet describing solar PV upgrade for an existing homes.

Information sheet describing tankless hot water heating systems in existing homes.

Information sheet describing solar hot water systems in existing homes.

Information about a roof retrofit using a metal, cool roof system.

Information sheet describing tankless hot water heating systems in existing homes.

Information sheet about envelope and roof moisture control retrofit for a home.

Information sheet about window retrofit strategies for hot-dry climates.

Fact sheet describing proper roof sheathing installation and illustrating fastening methods that will enhance the durability of a building in high-wind areas; also published in FEMA P-499 “Home Builder’s Guide to Coastal Construction: Technical Fact Sheet Series.”

Fact sheet describing recommended practices for the use of roofing underlayment as an enhanced secondary water barrier in coastal environments and optional installation methods; also published in FEMA P-499 “Home Builder’s Guide to Coastal Construction: Technical Fact Sheet Series.”

Q&A article discussing how to address moisture issues in an attic in a wet and humid coastal climate.

Fact sheet describing the importance of proper roof and deck flashing, and typical and enhanced flashing techniques for coastal homes; also published in FEMA P-499 “Home Builder’s Guide to Coastal Construction: Technical Fact Sheet Series.”

Article describing how insulating and air sealing unfinished attic spaces can lead to reduced energy bills in some homes.

Fact sheet describing guidance concerning lot selection and building siting considerations for coastal residential buildings, including factors that constrain siting decisions, coastal setback lines, common siting problems, and suggestions for builders, designers, and owners; also published in FEMA...

Report comparing the performance of seven differing types of residential water heating systems in a side-by-side test configuration over a full year period.

Fact sheet describing basic design and installation tips for various types of siding for high-wind regions, including vinyl, wood, and fiber cement and discusses sustainable design issues; also published in FEMA P-499 “Home Builder’s Guide to Coastal Construction: Technical Fact Sheet Series.”

Initiatives of smoke-free housing policies in New York State.

Guidelines to assist builders in designing and constructing homes equipped with a set of features that make the installation of solar energy systems after the completion of the home’s construction easier and less expensive.

The RERH specifications and checklists take a builder and a project design team through the steps of assessing a home’s solar resource potential and defining the minimum structural and system components needed to support a solar energy system.

Specifications to assist builders in designing and constructing homes equipped with a set of features that make the installation of solar energy systems after the completion of the home’s construction easier and less expensive.

Literature review from NFPA on the use of insulation to protect the piping in home fire sprinkler systems from freezing conditions.

ASTM designation regarding two radon control options for low-rise residential building construction. This standard was produced in the year 2008, and is available for preview and purchase at the reference link.

Detailed requirements for testing, exposure modeling, and allowable limits for modeled indoor air concentrations.

Standard that covers the minimum performance and acceptance criteria for an air barrier (AB) material or system for framed walls of low-rise buildings with the service life of the building wall in mind. This link directs to a preview of the version of the standard that was published in the year 2011...

Article describing ways to protect roofs from water infiltration by using self-adhering underlayment in vulnerable locations such as roof valleys, eave edges (to help deal with ice dams), rake edges, roofs to vertical walls (such as dormers), sidewall protection, the bottom of dormer valleys, and...

Report about the impact on the loads when common safety factors are applied to the load calculation process using two houses that meet the 2009 IECC prescriptive path modeled as the accurate baseline.

Document identifying differences between the requirements for construction documents for high performance housing and the documents that are typically produced for conventional housing.