Library

Factsheet describing the use of rigid foam insulation to meet energy efficiency requirements and minimize fire risks.

Website providing a link for purchasing NFPA 1141, Standard for Fire Protection Infrastructure for Land Development in Wildland, Rural, and Suburban Areas.

Standard 680 establishes definitions, classifications, test requirements, data requirements, ratings, operating requirements, marking and nameplate data and conformance conditions for residential air filter equipment.

Report covering coating and back venting wood based claddings and trim.

The 2017 publication update to the SEAOC Wind Committee and SEAOC Solar Photovoltaic Systems Sub-Committee's 2012 report.

Conference paper describing testing of the performance of fasteners used to attach rigid foam insulation to the exterior of walls.

Paper describing case studies on urban vegetation and greenways and their impacts on city climate and building performance.

Fact sheet describing best practices for flashing doors and windows to minimize air and water intrusion.

Document with information on preventing termites when using ICFs.

Webpage describing the standards, seminars, exams, etc regarding testing, adjusting and balancing (TAB).

Article outlining the importance of keeping dryer exhaust ducts clean.

Article describing the evolution of the IRC to permit class 3 vapor retarders (latex paint) in walls coupled with exterior continuous insulation to allow drying and reduce condensation risk.

Article describing how an affordable multifamily building achieved energy savings for the same cost as code-minimum construction.

Report documenting the process and outcomes involved in achieving the U.S. Department of Energy Zero Energy Ready Home (ZERH) program certification standards while helping homebuilders in Climate Zones 5 and 6 in the Upper Midwest achieve ZERH certification.

Case study about affordable housing in a mixed, humid climate.

This report describes how twenty homes were tested and monitored in the Zone 2 climate of Houston, Texas, U.S.A., to evaluate the humidity control performance and operating cost of six different integrated dehumidification and ventilation systems that could be applied by production homebuilders.

Report covering the migration of wind-blown embers in roof vents.

Fact sheet describing how to identify heat-related illness and what actions to take.

Resource that provides guidance when choosing products that meet WaterSense program requirements.

An article describing a way to protect drain and ventilation holes in brick veneer siding against pests. Selecting a fine screen mesh opening (1/55-inch or 0.5-mm) is important to guard against small insects such as subterranean termites.

Study showcasing the location of the highest uplift force on the hip, ridge, and perimeter regions of roofs, and thus roofing material needs for the most fasteners and adhesive at these locations.

Article discussing structural and nonstructural building components and illustrates a variety of wind-induced damages, including wind-driven rain infiltration.

Report and case study describing a retrofit project for single family homes in the Pacific Northwest.