Library

2015 edition of code for commercial buildings that brings together all structural, plumbing, mechanical, fuel gas, energy and electrical provisions for all buildings except detached one- and two-family residences and townhouses up to three stories.

Report providing builders in marine climates with guidance for building homes that have whole-house energy savings of 40% over the Building America benchmark with no added overall costs for consumers.

Standards book discussing the minimum standards of total system balance of HVAC systems.

Document describing three methods for elevating a home out of the flood zone.

Standard covering equipment sizing loads for single-family-detached homes, small multi-unit structures, condo­miniums, town houses and manufactured homes.

Technical manual from ACCA outlining correct methods for zoning of residential HVAC systems.

Report analyzing design heating load sizing methods for superinsulated homes in cold climates and comparing them to the actual energy usage to determine if the building load calculation methodology should be changed for calculating the design heating load of these homes.

This Best Practices Manual is the product of Hammer & Hand’s ongoing work to document and internally codify our standard operating procedures for construction practice.

Code establishing the rules of safety relating only to pressure integrity for the design, fabrication, and inspection of boilers and pressure vessels during construction which was published in the year 2017 and is available to order at the referenced link.

Code establishing the rules of safety relating only to pressure integrity for the design, fabrication, and inspection of boilers and pressure vessels during construction which was published in the year 2021 and is available to order at the referenced link.

Document providing guidance to U.S. home builders who want to accept the challenge.

Guide describing measures that builders in the cold and very cold climates can take to build homes that have whole-house energy savings of 40% over the Building America benchmark with no added overall costs for consumers.

Guidance document providing BA research teams and partners with specific information and approaches to identifying and overcoming potential barriers to Building America (BA) innovations arising in and/or stemming from codes, standards, and rating methods.

Report summarizing research results for the 30% energy savings level and demonstrates that lead builders can successfully provide 30% homes in the Marine Climate Region on a cost-neutral basis.

Document detailing how to build radon-resistant homes.

Training manual on how to locate ducts within conditioned space and compact design.

Report describing strategies to improve the aging steam heating systems in New York City to improve energy efficiency, reduce oil and gas usage, and cut maintenance costs.

Report outlining the steps developers can take to create high-performance standards on a community-wide scale.

A fact sheet providing information on termite species and how to prevent them from entering into your home.

Part of a larger LBNL report (Deep Energy Retrofit Guidance for the Building America Solutions Center), the Design and Construction Process chapter provides detailed guidance for each process phase: pre-planning, planning, construction, test-out and post-occupancy.

Part of a larger LBNL report (Deep Energy Retrofit Guidance for the Building America Solutions Center), the Lessons Learned chapter focuses on successful deep energy retrofit projects throughout the U.S.

Part of a larger LBNL report (Deep Energy Retrofit Guidance for the Building America Solutions Center), the Occupant Behavior chapter discusses how to assess homeowner behavior patterns and use these patterns to enhance overall energy savings.

Part of a larger LBNL report (Deep Energy Retrofit Guidance for the Building America Solutions Center), the Reducing costs and Increasing Cost-Effectiveness chapter provides suggestions for controlling deep retrofit costs, including both 'do's' and 'don'ts'.

Report outlining the issues with using existing ducts with a new low-load HVAC system, which reduces throw at supply registers causing decreased mixing of supply and room air, leading to potential thermal comfort complaints.

This publication provides a set of best practices for improving indoor air quality in conjunction with energy upgrade work in homes.

Article describing a 9-step process to getting rid of rats and mice, and some preventative actions to take.

Website blog with guidance about calculating heat-loss.

A website providing a checklist of important areas to check when sealing holes inside and outside of the home to prevent entry by rodents and other outside pests.

Factsheet describing tips for building or renovating with a focus on disaster resistance.

Correcting pressure imbalances in your HVAC system can result in a healthier, more efficient home.

Central return designs require an open pathway between the room and the heart of the house where the return grill is located.

A factsheet providing information on how to prevent pests from entering the home by sealing cracks and openings.

Article explaining how to use integrated pest management to choose methods of pest control that are safe and effective.

Standard technical manual with information about HVAC balancing, testing air and hydronic systems.

Article describing the flashing of roofs and what to look for, targeted at home inspectors.

Article describing mulching with lawn clippings.

Report discussing development of scopes of work and quality management for builders in mixed-humid climates.

Website providing information on tsunamis, earthquakes, tornadoes, hurricanes, thunderstorms and more.

NWCOA website homepage.

Report investigating what motivates remodelers to become energy-focused and what technical knowledge that need to be energy-focused.

Website of the New York Department of Environmental Conservation.

Report providing detailed steps for builders, architects, and property managers to take for integrated pest management for control of a variety of pests including insects, rodents, and birds.

Report presenting ways public housing authorities (PHAs) can develop packages of energy efficiency retrofit measures the PHAs can cost-effectively implement with their own staff in the normal course of housing operations at the time when units are refurbished between occupancies.

Report designed to help a builder understand quality management and its role in transitioning from conventional to HPH building and remodeling.

Website providing information about how to keep the properties rat-free and address conditions that can lead to rats.

Report describing steps homeowners can take to improve the indoor air quality in their home, including ventilating, preventing pests, and reducing pollutants in the home.

Guide describing ways builders can block off entry points and otherwise make homes inhospitable to all manner of pests.

Manual describing methods for rodent-proofing buildings.

Website providing information about how to prevent rodent entry in homes.

Manual describing the installation process for Craneboard insulated vinyl siding; while installation is similar across insulated vinyl siding products, see manufacturers for specific guidance.