Library

2009 edition of code establishing minimum regulations for plumbing facilities, including fixtures, water heaters, water supply and distribution, sanitary drainage, storm drainage, etc.

2012 edition of code establishing minimum regulations for plumbing facilities, including fixtures, water heaters, water supply and distribution, sanitary drainage, storm drainage, etc.

Code set from IAPMO explaining plumbing standards. 2018 publication.

Handbook to help property owners understand the rules, procedures, standards, and criteria that apply to the environmental resource permit (ERP) program under Part IV of Chapter 373 of the Florida Statutes.

Broschure detailing water control strategies for building openings (e.g., vents and drainpipes).

Expert Meeting about interior insulation retrofit of mass masonry wall assemblies held on July 30, 2011.

Article describing methods to manage moisture, rainwater, and vapor in basements and crawlspaces.

Web article discussing the primary approaches to waterproofing concrete foundations.

Research study presenting results of an existing home monitoring project designed to measure wall cavity moisture characteristics.

Report covering control of hydrostatic pressure in wall assemblies.

Blog entry describing methods for insulating basement walls on the interior or exterior.

Report focusing on managing the driving forces that move air and water vapor across the building envelope.

Document describing good practices for insulating basements in new and existing homes.

Document providing information on basement insulation, air sealing and water management retrofits.

Report summarizing the importance of properly insulating and air sealing masonry walls, providing step by step instructions and approaches.

Report describing the work conducted for high performance hybrid assemblies.

An NFPA standards document that provides minimum requirements for the design, construction, installation, and maintenance of tanks and accessory equipment that supply water for private fire protection.

Report covering wind loading on roofing assemblies.

How hard can it be to insulate a flat sheet of concrete? I mean you only have three choices – on the top, on the bottom, or on the edge. OK, you might have some combination of the three as well.

Presentation describing the challenges of insulating an existing basement, presented to the Building America residential energy-efficiency stakeholder meeting.

Article describing a method for flashing roof vent boots, describing how to flash the pipe, how to flash over and under the pan, and finish by shaping the shingles, as well as addressing potential water leakage by adding an additional seal with EPDM flashing tape with a butyl adhesive backing to the...

Report summarizing current research, summarizes issues that have been experienced with current best practices, and recommends ways in which the best practices can be improved for water managing sheathings.

Manual showing how to properly use grass swales to manage excess water runoff.