Library

Report providing a collection of fact sheets describing guidance for constructing homes in wildfire zones.

Article describing the causes that form ice dams, as well as solutions for preventing future ice dams on roofs, focusing on air sealing to prevent hot air leakage.

Article from RMI on how climate change is leading to an increase in critical extreme heat hours and what smart building strategies can be taken to mitigate some of these effects including paint color and insulation.

Information sheet presenting the correct methods for building an insulated cathedral ceiling.

Article from Washington Post on passive cooling measures for homes during extreme heat.

Article from Montana State University Extension explaining how proper insulation techniques can greatly reduce the risks of ice dams on roofs in cold climate zones.

Checklist for verifying FORTIFIED levels and documentation needed.

A structural insulated panel (SIP) roof has no embedded lumber in the structure, and therefore nothing substantial for attaching PV array and solar hot water mounts. Single or double lumber splines could be put into the panels, or I-joists at 4-foot intervals could be added.

Code describing the requirements for existing site-built single-family homes to receive roof-to-wall retrofits when re-roofing.

A document aimed at reducing the vulnerability of a gable end roof to wind damage in a hurricane.

Report describing the hurricane retrofit guide with focus on walls and wooded framed walls.

Article describing the effect metal roofs have on thermal performance in hot-humid climates.

Article describing the second step of a three-step process for the installation a tubular skylight, using peel-and-stick flashing tape instead of roof cement, and integrating the roof underlayment with the flashing.

Article describing how to counterflash a chimney by tucking the upper pieces of counterflashing into the chimney mortar joints and overlapping them over the various pieces of base flashing, which are nailed to the roof deck.

Article describing the insurance savings of a home with a hip roof versus a gable roof from the perspective of an insurance advisor.

Article describing how the configuration of surrounding buildings affects the wind loads on a hip roof in a low-rise building.

Report discussing how to create livable space in the attic that meets IRC code requirements by either creating a ventilated roof assembly, or and unvented attic assembly.

Report describing ways to retrofit a home to make it more hurricane resistant.

Article showing steps for kick out flashing at roof-wall intersection.

Article describing a technique for installing a skylight and avoiding potential water leaks with the use of a peel-and-stick (or self-adhesive) membrane under the flashing.

Web article describing many ways homeowners, contractors, and builders can make homes more resistant to hurricanes, tornadoes, high winds, floods, and hail.

Fact sheet describing important roof-to-wall and wall-to-foundation connection details for masonry construction in coastal areas, including load paths, building materials, and reinforcement; also published in FEMA P-499 “Home Builder’s Guide to Coastal Construction: Technical Fact Sheet Series.”

Article describing the flashing of roofs and what to look for, targeted at home inspectors.

Article describing methods for insulating and air sealing vented and unvented roofs in various climates zones.

This Measure Guideline provides design and construction information for a deep energy enclosure retrofit solution of a flat roof assembly.

Study investigating measured cooling energy savings in homes across the U.S. from the installation of roofing with higher solar reflectance.

A presentation describing the standards regarding who is responsible for what part of the design to ensure the roof truss is properly designed and braced.

An installation training manual discussing the installation of metal roofing materials and related accessories, for both new construction and retrofit projects.

A Recovery Advisory guide reccomending practices for designing and installing metal roof systems that will enhance wind resistance in high-wind regions (i.e., greater than 90-miles per hour [mph] gust design wind speed).

Report covering the selection of roof vents for rainwater resistance.

This report requires all elements of rooftop PV panel systems to be designed for component and cladding pressures per ASCE 7-10.

Report providing extensive guidance on controlling moisture in building envelopes through proper selection and installation on air, water, thermal, and vapor barriers.

Standard covering overs mounting systems, including mounting devices, clamping devices and ground lugs for use with photovoltaic modules and panels and contains requirements for ground-mounted and roof systems as part of a nonstructural building component.

Guide providing information on controlling attic ductwork sweating.

A document providing guidance on integrating a PV array with a roof system.

Study examining how design features, such as building envelope openings and compartmentalization, affect the wind pressure in typical low-rise buildings with gable and hip roofs.

Report covering wind loading on roofing assemblies.

Large scale simulation study investigating the effects of cool roofs and walls on buildings of various vintages across the U.S., with special attention given to California.

Website providing guidance on how to reduce the risk of damage to a home from hail.

Webpage providing guidance for homeowners on how much snow weight a typical roof can handle and when to consider removing snow from the roof.

Article describing how ice dams form on residential roofs, how they damage homes, and solutions to prevent future dams.

Fact sheet from Wisconsin Focus on Energy explaining how to prevent future ice dams on homes by learning about their formation and mitigation of contributing factors.

Case study describing the External Thermal and Moisture Management System developed by the NorthernSTAR Building America Partnership for retrofitting roofs with rigid foam over the roof deck, especially on one and a half-story homes.

List of recommendations from IBHS on how to protect homes from ice dam formation.

Website providing an online calculator for determining energy and cost savings from installing radiant barriers in attics.

Fact sheet describing analysis of potential heating and cooling savings from radiant barriers in attics.

U.S. Department of Energy's website describing radiant barriers in homes.

Website with answers to some of the most commonly asked questions about attic radiant barriers.

Report covering the performance of residential buildings during three hurricanes impacting Florida in 2004.

Information sheet with the definition and uses for a raised truss.