Library

Checklist providing recommendations for the right tape in order to reduce the risk of leaks during storms with wind-driven rain.

Standard describing GREENGUARD Emission Criteria for use with GREENGUARD Certification Program for Low Emitting Products.

Guide describing the requirements by FORTIFIED Home™ for improving the home's resistance to high wind and hail.

Brochure describing advanced framing techniques.

Article from NREL on wall construction guidelines for homes in hot climate zones.

Report containing 37 fact sheets that provide technical guidance and recommendations concerning the construction of coastal residential buildings.

A guide that summarizes building materials and design considerations for increasing wildfire-resistivity of homes in areas that are prone to wildfires.

A starting point for ballparking and comparing the cost of different siding materials and a brief overview of the pros and cons of different siding materials.

Article describing how omission of two small but critical wall details, a kick-out flashing and a weep screed, lead to extensive water damage to a wall.

Factsheet describing proper methods for installing vinyl siding and soffit coverings in high wind and coastal areas.

Checklist for verifying FORTIFIED levels and documentation needed.

A structural insulated panel (SIP) roof has no embedded lumber in the structure, and therefore nothing substantial for attaching PV array and solar hot water mounts. Single or double lumber splines could be put into the panels, or I-joists at 4-foot intervals could be added.

Wildfire guidance for homes located in the wildland urban interface, focused on site design and individual pieces of the home.

Ignition resistant residential construction and landscaping guidelines from FireSafe Montana.

An impact test report from projectile missile tests against brick veneer, verifying that brick veneers perform well to resisting hurricane force wind driven debris.

Site showing flame spread ratings and definitions for common building materials.

Article from Building Science Corporation explaining 'wash and wear buildings' that are designed to be flooded and washed out afterwards.

PDF detailing the inspection and verification guidance for WaterSense labeled new homes including indoor and outdoor efficiency requirements, and homeowner and building management education.

Report providing general guidelines for the installation of rolled erosion control products.

EPA’s 2008 Lead-Based Paint Renovation, Repair and Painting (RRP) Rule (as amended in 2010 and 2011), aims to protect the public from lead-based paint hazards associated with renovation, repair and painting activities.

Webpage featuring hundreds of illustrations of masonry construction details for brick, congrete, stone, tile, stucco, etc.

FEMA mitigation assessment team report following Hurricane Charley in Florida including observations, recommendations, and technical guidance for retrofitting hurricane-damaged homes.

FEMA mitigation assessment team report following Hurricane Ivan in Florida and Alabama including observations, recommendations, and technical guidance.

EPA guidance document providing information on moisture control in buildings.

Brochure discussing specific practices for mitigating moisture and mold during the construction process.

Online course describing mold and mold remediation for environmental and public health professionals.

Document describing common questions about moisture, mold, and wood.

Article describing mulch requirements and benefits.

Pamphlet describing different types of mulches and their benefits.

Information sheet with nail withdrawl capacities in OSB.

Fact sheet providing guidance on alternative building materials and techniques in coastal environments, including Engineered Wood Products, SIPs, ICFs, Prefabricated Shear Walls and Moment Frames, Sprayed Closed-Cell Foam Insulation, Advanced Wall Framing, and Modular Houses; also published in FEMA...

A fact sheet educating the public on how to appropriately ground portable generators and the hazards associated with their use.

Standards for paints and coatings.

A study on how fires spread through exterior building envelopes with discussion on how fires propagate in a rain screen cavity.

Standards for requirements, performance, construction, workmanship and others for structural-use panels.

Report providing information on performance of mortars and concrete containing PCMs.

Manual describing design, detailing, material selection and troubleshooting for plaster, IEFs, and drywall, with information on continuous insulation, air barriers, rain screens, and ratings for fire and sound.

City of Plymouth webpage providing information on the Plymouth Community Center Project.

Database of approved products that meet the requirements of the High Velocity Hurricane Zone.

This page provides important information on how to protect yourself and your family if you suspect that you might have vermiculite insulation from Libby, Montana.

An example of a form a building codes department created to ensure builders are fully aware and have taken steps to provide drainage so that water doesn’t accumulate behind siding. This example is from the city of Newberg, Oregon.

Guide describing ways builders can block off entry points and otherwise make homes inhospitable to all manner of pests.

Report from FEMA on how to reduce damage from localized flooding including planning, drainage, building codes and retrofits, and regulations.

Report describing the testing of various siding materials for their ability to resist bullets from small firearms.

Website providing an introduction to the concepts and principles of seismic design.

Report from FEMA describing techniques for floodproofing structures.

Description webpage providing information about home fire safety during sever weather for consumers.

Website providing the pros and cons of different siding materials for home building, including wood, vinyl, fiber cement, stucco, brick, metal, and stone.

Report informing building stakeholders about the risks a snow event poses to their buildings, preventative measures to take before the snow season, and actions that should be taken before, during, and after a snow event.

California Energy Commission report presenting the concept of cool walls and providing guidelines for their building- and climate-appropriate use to conserve energy and reduce emissions.