Library

Information guide describing issues with concrete floors, in multiple climate zones.

Document discussing moisture considerations and testing techniques for concrete floors.

Report covering insulating crawlspaces.

Article describing the process of constructing concrete walls

Research report anayzing the results of a large retrofit project, turining an old school into near zero energy consumption apartments in Greenfield MA.

Article describing the use of whole-house fans to provide cooling in the region surrounding Sacramento, CA.

Report providing recommendations to builders regarding how to reduce cooling loads, use air-circulation fans, natural ventilation, window and building design for natural ventilation, and whole-house fans.

Short report providing tips on how to reduce heat gain and passively cool a home.

Standard describing prediction, mitigation, and reduction of moisture damage to the building envelope, materials, components, systems, and furnishings, depending on climate, construction type, and HVAC system operation; the webstore allows preview or full purchase.

Report providing guidance on designing buildings to be flood resistant.

Article from Green Building Advisor on strategies to take when building homes to reduce the need for air conditioning, including insulation, windows, site selection, and roofing.

The main principle of smart ventilation used in this study is to shift ventilation from time periods with large indoor-outdoor temperature differences, to periods where these differences are smaller, and their energy impacts are expected to be less.

Research report describing the development of standardized test methods for PM2.5 and CO2 sensors enabling reliable, low-cost indoor air quality monitoring and improvement.

Case study describing foundation wall moisture studies at a research facility in Minnesota run by Building America team NorthernSTAR.

Report providing an introduction to the NEHRP recommended seismic provisions for new buildings and other structures.

Article describing earthship homes.

Bulletin describing the components of ECM motors and comparing their efficiency with PSC motors.

Report describing an investigation into multiple occupancy-based ventilation control strategies and the associated energy savings.

This study evaluates the energy, humidity and indoor air quality implications of residential ventilation cooling in all US IECC climate zones.

Technical report evaluating the energy savings potential of radiative cooling technologies, particularly photonic 'selective emittance' materials.

Factsheet describing the benefits of purchasing and installing ENERGY STAR rated fans and ventilation products.

Program criteria for residential exhaust fans used for ventilation.

Information sheet with details on a building enclosure designed for Albuquerque, NM, as an example for building enclosures built for hot-dry and mixed-dry climates.

This report evaluates the performance of variable-capacity comfort systems, with a focus on inverter-driven, variable-capacity systems, as well as proposed system enhancements.

Report describing the evaluation and selection of ventilation systems for homes retrofitted for energy aesthetic and health/safety improvements in Las Vegas.

Document reviewing four cold-climate northern Illinois energy efficiency retrofit programs to identify practices, tools, and approaches to streamline and reduce costs of comprehensive retrofits, and to improve the consistency of audit and retrofit delivery practices across different programs.

Case study on exhaust ventilation and corresponding outdoor air intake strategies implemented in high-performance new-construction multifamily buildings.

Report detailing the effects of replacing PSC motors with more efficient, variable-speed motors.

Research study documenting market-ready energy solutions to improve the efficiency of new affordable housing in the marine climate of Washington State.

Technical report describing the evaluation of four different ventilation strategies for providing make-up air in high-performance, new construction multifamily buildings in the Northeast, emphasizing the challenges posed by increasing airtightness standards and the variability of system performance...

Report describing research that helps inform best practices for air-sealing multifamily buildings in the Northeast.

Case study describing novel technique for installing exterior spray foam on foundation walls that uses high-pressure water sprayer and a “hydro vac” to remove dirt along the foundation wall.

Study characterizing how foundation heat exchangers (FHXs) used in residential ground source heat pump systems represent a potential cost savings due to their lesser first cost over other types of heat exchangers.

Documents describing the similarities and differences between the National Flood Insurance Program (NFIP) minimum requirements and the requirements of the International Codes® (I-Codes®) and ASCE 24, Flood Resistant Design and Construction, a standard referenced by the I-Codes., and illustrating...

Fact sheet discussing designs for prefabricated safe rooms built to ICC 500 standards mentioned in FEMA P-361.

Journal article reporting on field experience of unvented cathedralized (UC) attics in several environments in the United States.

Report about field testing that characterizes the uniformity of room-to-room ventilation air distribution under various operating conditions by examining multi-zone tracer gas decay curves and calculating local age-of-air.

Technical report on a field validation study that utilizes low-cost indoor air quality sensors to assess a smart ventilation system's effectiveness in maintaining acceptable indoor humidity in low-load homes in humid environments, revealing that while the smart ventilation algorithm demonstrated...

Research report assessing the moisture and cooling load impacts of airtightness and mechanical ventilation in homes in hot-humid climates.

Research study outlining savings from reducing air infiltration, with and without the addition of mechanical ventilation, using two identical laboratory homes designed to model existing Florida building stock.

Report describing dry floodproofing technologies for non-residential buildings, including information about regulatory requirements, design considerations, and descriptions of floodproofing methods and equipment.

Article describing the effective R-values of various subslab insulation products, including foil bubble pack.

Checklist highlighting the requirement for metal structural connections and materials fasteners used to retrofit or construct FORTIFIED buildings less than 3,000 ft from saltwater to be suitably protected from corrosion.

Checklist intending to clarify FORTIFIED Home™ eligibility requirements that relate to a home’s foundation.

Handbook providing guidance on the design and construction of foundations for homes, including insulation, air sealing, and water management details for basements, crawlspaces, and slabs.

Article describing a numerical model that can be used to size foundation heat exchanger (FHX) systems.

Web article discussing the primary approaches to waterproofing concrete foundations.

Article describing what the building codes say about frost-protected shallow foundations as a cost-saving alternative to conventional concrete foundations.

Guides describing frost-protected shallow foundations as an alternative method for building an energy-efficient foundation for a house in a cold climate that uses less concrete and saves on labor.