Library

Fact sheet describing a report providing best practices for reducing damages from floods to manufactured homes.

Fact sheet providing an overview of the FEMA document Wind Retrofit Guide for Residential Buildings.

Guide providing engineering seismic design and building practices based on post-earthquake research.

Report providing builders in marine climates with guidance for building homes that have whole-house energy savings of 40% over the Building America benchmark with no added overall costs for consumers.

Document describing three methods for elevating a home out of the flood zone.

Article describing how an airtight home shell helps achieve a tight envelope that is energy efficient and cost effective.

Report describing approaches to insulating basements in homes built to meet Energy Star levels of performance of heat loss reduction.

Article from California Earthquake Authority on the benefits of retrofitting homes to withstand earthquake forces, with a focus on foundations, walls, and chimneys.

This Best Practices Manual is the product of Hammer & Hand’s ongoing work to document and internally codify our standard operating procedures for construction practice.

Information sheet about insulating slabs.

Document providing guidance to U.S. home builders who want to accept the challenge.

Guide describing measures that builders in the cold and very cold climates can take to build homes that have whole-house energy savings of 40% over the Building America benchmark with no added overall costs for consumers.

Guidance document providing BA research teams and partners with specific information and approaches to identifying and overcoming potential barriers to Building America (BA) innovations arising in and/or stemming from codes, standards, and rating methods.

Report summarizing research results for the 30% energy savings level and demonstrates that lead builders can successfully provide 30% homes in the Marine Climate Region on a cost-neutral basis.

Article describing the control layers (air, thermal, and vapor barriers) needed to build homes successfully in very cold locations.

Document detailing how to build radon-resistant homes.

Report about the fundamental concepts that must be understood at the planning or initial nspection of existing homes regarding surface and ground water management.

Article describing correct ways to eliminate water damage by incorporating a sacrificial layer to foundation walls and footings.

Report aimed to quantify the impact of closed crawlspaces in new homes, and investigate modeling software to ensure accuracy of energy consumption predictions in these homes.

Guide about designing and installing closed crawlspaces in the Southeast.

Volume 1 of a two-volume report providing a comprehensive approach to planning, siting, and risk management for homes constructed in coastal environments.

Website discussing building foundation problems caused by settling soil in Colorado.

Report outlining the steps developers can take to create high-performance standards on a community-wide scale.

Information guide describing issues with concrete floors, in multiple climate zones.

Document discussing moisture considerations and testing techniques for concrete floors.

Report covering insulating crawlspaces.

Article describing the process of constructing concrete walls

Part of a larger LBNL report (Deep Energy Retrofit Guidance for the Building America Solutions Center), the Design and Construction Process chapter provides detailed guidance for each process phase: pre-planning, planning, construction, test-out and post-occupancy.

Part of a larger LBNL report (Deep Energy Retrofit Guidance for the Building America Solutions Center), the Lessons Learned chapter focuses on successful deep energy retrofit projects throughout the U.S.

Part of a larger LBNL report (Deep Energy Retrofit Guidance for the Building America Solutions Center), the Occupant Behavior chapter discusses how to assess homeowner behavior patterns and use these patterns to enhance overall energy savings.

Part of a larger LBNL report (Deep Energy Retrofit Guidance for the Building America Solutions Center), the Reducing costs and Increasing Cost-Effectiveness chapter provides suggestions for controlling deep retrofit costs, including both 'do's' and 'don'ts'.

Report providing guidance on designing buildings to be flood resistant.

Case study describing foundation wall moisture studies at a research facility in Minnesota run by Building America team NorthernSTAR.

Report providing an introduction to the NEHRP recommended seismic provisions for new buildings and other structures.

Information sheet with details on a building enclosure designed for Albuquerque, NM, as an example for building enclosures built for hot-dry and mixed-dry climates.

Case study describing novel technique for installing exterior spray foam on foundation walls that uses high-pressure water sprayer and a “hydro vac” to remove dirt along the foundation wall.

Study characterizing how foundation heat exchangers (FHXs) used in residential ground source heat pump systems represent a potential cost savings due to their lesser first cost over other types of heat exchangers.

Documents describing the similarities and differences between the National Flood Insurance Program (NFIP) minimum requirements and the requirements of the International Codes® (I-Codes®) and ASCE 24, Flood Resistant Design and Construction, a standard referenced by the I-Codes., and illustrating...

Fact sheet discussing designs for prefabricated safe rooms built to ICC 500 standards mentioned in FEMA P-361.

Report describing dry floodproofing technologies for non-residential buildings, including information about regulatory requirements, design considerations, and descriptions of floodproofing methods and equipment.

Article describing the effective R-values of various subslab insulation products, including foil bubble pack.

Checklist highlighting the requirement for metal structural connections and materials fasteners used to retrofit or construct FORTIFIED buildings less than 3,000 ft from saltwater to be suitably protected from corrosion.

Checklist intending to clarify FORTIFIED Home™ eligibility requirements that relate to a home’s foundation.

Handbook providing guidance on the design and construction of foundations for homes, including insulation, air sealing, and water management details for basements, crawlspaces, and slabs.

Article describing a numerical model that can be used to size foundation heat exchanger (FHX) systems.

Web article discussing the primary approaches to waterproofing concrete foundations.

Article describing what the building codes say about frost-protected shallow foundations as a cost-saving alternative to conventional concrete foundations.

Guides describing frost-protected shallow foundations as an alternative method for building an energy-efficient foundation for a house in a cold climate that uses less concrete and saves on labor.

Article describing frost-protected shallow foundations with construction drawing details.