Library

Web article describing common issues that can cause refrigerant system flare joints to leak.

2009 edition of code establishing minimum regulations for plumbing facilities, including fixtures, water heaters, water supply and distribution, sanitary drainage, storm drainage, etc.

Fact sheet describing a report providing best practices for reducing damages from floods to manufactured homes.

Fact sheet providing an overview of the FEMA document Wind Retrofit Guide for Residential Buildings.

2012 edition of code establishing minimum regulations for plumbing facilities, including fixtures, water heaters, water supply and distribution, sanitary drainage, storm drainage, etc.

2015 edition of code establishing minimum regulations for plumbing facilities, including fixtures, water heaters, water supply and distribution, sanitary drainage, storm drainage, etc.

Guide providing engineering seismic design and building practices based on post-earthquake research.

2018 edition of code establishing minimum regulations for plumbing facilities, including fixtures, water heaters, water supply and distribution, sanitary drainage, storm drainage, etc.

Fact sheet describing air-sealing concerns and remedies, including HRV/ERV installation, caulking, spray foam, and weatherstrip installation.

Article describing how an airtight home shell helps achieve a tight envelope that is energy efficient and cost effective.

Report describing approaches to insulating basements in homes built to meet Energy Star levels of performance of heat loss reduction.

Article describing how demand plumbing systems send cold water back to the water heater until hot water arrives at the sink, shower or other fixture where it is needed.

Article from California Earthquake Authority on the benefits of retrofitting homes to withstand earthquake forces, with a focus on foundations, walls, and chimneys.

Case study describing solar thermal and photovoltaic systems in new construction.

Information sheet about insulating slabs.

Case study describing solar thermal and photovoltaic systems in new construction.

Case study describing solar thermal and photovoltaic systems in new construction.

Website with consumer and contractor information about building codes and regulations for solar water heating systems.

Article describing the control layers (air, thermal, and vapor barriers) needed to build homes successfully in very cold locations.

Report about the fundamental concepts that must be understood at the planning or initial nspection of existing homes regarding surface and ground water management.

Article describing correct ways to eliminate water damage by incorporating a sacrificial layer to foundation walls and footings.

Report aimed to quantify the impact of closed crawlspaces in new homes, and investigate modeling software to ensure accuracy of energy consumption predictions in these homes.

Guide about designing and installing closed crawlspaces in the Southeast.

Volume 1 of a two-volume report providing a comprehensive approach to planning, siting, and risk management for homes constructed in coastal environments.

Website discussing building foundation problems caused by settling soil in Colorado.

Information guide describing issues with concrete floors, in multiple climate zones.

Document discussing moisture considerations and testing techniques for concrete floors.

Report covering insulating crawlspaces.

Article describing the process of constructing concrete walls

Report describing the monitored long-term performance of two solar domestic water heating systems in northern climates.

Report providing guidance on designing buildings to be flood resistant.

Website providing lists of WaterSense-qualified products for home plumbing and irrigation equipment that meet the requirements of the U.S. Environmental Protection Agency’s (EPA’s) WaterSense program.

A quick guide from the California Division of the State Architect (DSA) explaining the three types of gas shutoff devices to stop the flow of natural gas into buildings in the event of an earthquake or rupture of the gas line.

Case study describing foundation wall moisture studies at a research facility in Minnesota run by Building America team NorthernSTAR.

Report providing an introduction to the NEHRP recommended seismic provisions for new buildings and other structures.

Information sheet with details on a building enclosure designed for Albuquerque, NM, as an example for building enclosures built for hot-dry and mixed-dry climates.

Report exploring feasibility of designing prescriptive retrofit measure packages for typical Chicago region multifamily buildings in order to achieve 25% source energy savings.

Case study describing novel technique for installing exterior spray foam on foundation walls that uses high-pressure water sprayer and a “hydro vac” to remove dirt along the foundation wall.

Study characterizing how foundation heat exchangers (FHXs) used in residential ground source heat pump systems represent a potential cost savings due to their lesser first cost over other types of heat exchangers.

Documents describing the similarities and differences between the National Flood Insurance Program (NFIP) minimum requirements and the requirements of the International Codes® (I-Codes®) and ASCE 24, Flood Resistant Design and Construction, a standard referenced by the I-Codes., and illustrating...

Documents describing Flood Resistant Provisions of the international codes (including the international building, residential, exiting building, mechanical, plumbing, fuel gas, fire, swimming pool and spa, private sewage disposal, and code council performance codes) and summaries of changes from the...

Fact sheet discussing designs for prefabricated safe rooms built to ICC 500 standards mentioned in FEMA P-361.

Factsheet describing backflow valve benefits and tips.

Report describing dry floodproofing technologies for non-residential buildings, including information about regulatory requirements, design considerations, and descriptions of floodproofing methods and equipment.

Article describing the effective R-values of various subslab insulation products, including foil bubble pack.

Website with information for consumers about solar thermal systems for homes.

Checklist highlighting the requirement for metal structural connections and materials fasteners used to retrofit or construct FORTIFIED buildings less than 3,000 ft from saltwater to be suitably protected from corrosion.

Checklist intending to clarify FORTIFIED Home™ eligibility requirements that relate to a home’s foundation.

Handbook providing guidance on the design and construction of foundations for homes, including insulation, air sealing, and water management details for basements, crawlspaces, and slabs.

Article describing a numerical model that can be used to size foundation heat exchanger (FHX) systems.