Skip to main content

Resources

Explore a library of home construction and renovation guidance and easily search through galleries containing hundreds of building science-related photos, drawings, videos, CAD files, case studies, and presentations.

Filter

View Library

Showing 529 - 552 of 689 results:

Image:

Terminate 4" tape with 2" wide tape placing tape offset high on the joint, 2/3 of the tape should be adhered to the sheet of insulation

Terminate 4" tape with 2" wide tape placing tape offset high on the joint, 2/3 of the tape should be adhered to the sheet of insulation
Image:

The “continuous waterproofing” approach can be used to control groundwater in cases where the building foundation is below the groundwater table.

The “continuous waterproofing” approach can be used to control groundwater in cases where the building foundation is below the groundwater table.
Image:

The “draw down” approach can be used to control groundwater in cases where the building foundation is below the groundwater table.

The “draw down” approach can be used to control groundwater in cases where the building foundation is below the groundwater table.
Image:

The “perimeter cutoff and dewatering” approach can be used to control groundwater in cases where the building foundation is below the groundwater table.

The “perimeter cutoff and dewatering” approach can be used to control groundwater in cases where the building foundation is below the groundwater table.
Image:

The attic kneewall and the open floor cavities under kneewall are both sealed and insulated in one step with spray foam insulation

The attic kneewall and the open floor cavities under kneewall are both sealed and insulated in one step with spray foam insulation
Image:

The black coating on these walls is a liquid-applied asphalt-based air and moisture barrier.

The black coating on these walls is a liquid-applied asphalt-based air and moisture barrier.
Image:

The builder in this very cold climate installed three layers of unfaced mineral wool batt in the double wall with a code-required vapor barrier between the middle and inner layers of wall insulation that is taped to barriers in the ceiling and floor.

The builder in this very cold climate installed three layers of unfaced mineral wool batt in the double wall with a code-required vapor barrier between the middle and inner layers of wall insulation that is taped to barriers in the ceiling and floor.
Image:

The builder installed 1.5 inches of soy-based spray foam on the outside of the walls over the OSB sheathing, then kept a ¾ inch gap between the foam and the brick veneer siding to allow moisture vapor from the bricks to dissipate.

The builder installed 1.5 inches of soy-based spray foam on the outside of the walls over the OSB sheathing, then kept a ¾ inch gap between the foam and the brick veneer siding to allow moisture vapor from the bricks to dissipate.
Image:

The builder installed a rain screen product that provides an air gap and drainage plane between the coated OSB sheathing and the cladding; the fabric layer folded over the bottom edge forms an insect screen.

The builder installed a rain screen product that provides an air gap and drainage plane between the coated OSB sheathing and the cladding; the fabric layer folded over the bottom edge forms an insect screen.
Image:

The builder laid down a 4-inch base of aggregate rock, then covered that with a plastic vapor barrier that is taped at all seams and around all penetrations before installing the rigid foam under-slab insulation.

The builder laid down a 4-inch base of aggregate rock, then covered that with a plastic vapor barrier that is taped at all seams and around all penetrations before installing the rigid foam under-slab insulation.
Image:

The condensate line (amber-colored plastic tube) from the high-efficiency furnace drains into the sewer via the same drain pipe as the clothes washer

The condensate line (amber-colored plastic tube) from the high-efficiency furnace drains into the sewer via the same drain pipe as the clothes washer
Image:

The drain pipe should include a trap and a clean-out with a removable cap

The drain pipe should include a trap and a clean-out with a removable cap
Image:

The drywall above the dropped ceiling duct chase extends beyond adjoining top plates for a continuous air barrier

The drywall above the dropped ceiling duct chase extends beyond adjoining top plates for a continuous air barrier
Image:

The entire roof of the home is covered with an ice-and-water shield to help protect against moisture damage.

The entire roof of the home is covered with an ice-and-water shield to help protect against moisture damage.
Image:

The furnace filter slot cover should fit tightly to minimize air leakage but it should not be taped or caulked to enable frequent filter replacements.

The furnace filter slot cover should fit tightly to minimize air leakage but it should not be taped or caulked to enable frequent filter replacements.
Image:

The goal of foundation moisture management is to construct the basement, crawlspace, or slab in a way that keeps moisture from getting in in the first place

The goal of foundation moisture management is to construct the basement, crawlspace, or slab in a way that keeps moisture from getting in in the first place
Image:

The HVAC equipment's condensate drain pan is equipped with a water-level detection device that will shut off the equipment if the water level pan in the pan gets too high

The HVAC equipment's condensate drain pan is equipped with a water-level detection device that will shut off the equipment if the water level pan in the pan gets too high
Image:

The incremental cost of EV charging infrastructure.

The incremental cost of EV charging infrastructure.
Image:

The leaks in this foundation wall have been injection sealed to prevent water infiltration into the foundation.

The leaks in this foundation wall have been injection sealed to prevent water infiltration into the foundation.
Image:

The light fixture is connected to the exhaust fan with an electric wire which is sometimes hard wired but in this case is plugged in so it can be unplugged to clean the light fixture and access the fan for cleaning

The light fixture is connected to the exhaust fan with an electric wire which is sometimes hard wired but in this case is plugged in so it can be unplugged to clean the light fixture and access the fan for cleaning
Image:

The metal head flashing over the window trim angles out slightly to provide a drip edge so rain water will drop away from the window instead of rolling down onto the window trim.

The metal head flashing over the window trim angles out slightly to provide a drip edge so rain water will drop away from the window instead of rolling down onto the window trim.
Image:

The nut holding the light housing in place in this combination exhaust fan/light can be unscrewed by hand

The nut holding the light housing in place in this combination exhaust fan/light can be unscrewed by hand
Image:

The original corner seam is air-sealed with caulk, then rigid foam is installed on the existing garage ceiling and walls, and finally covered with drywall.

The original corner seam is air-sealed with caulk, then rigid foam is installed on the existing garage ceiling and walls, and finally covered with drywall.
Image:

The Perfect Wall includes water, air, thermal, and vapor layers with continuous insulation exterior of the sheathing to reduce the condensation potential in the wall.

The Perfect Wall includes water, air, thermal, and vapor layers with continuous insulation exterior of the sheathing to reduce the condensation potential in the wall.