Library

Web article describing common issues that can cause refrigerant system flare joints to leak.

2009 edition of code establishing minimum regulations for plumbing facilities, including fixtures, water heaters, water supply and distribution, sanitary drainage, storm drainage, etc.

2012 edition of code establishing a baseline for existing building retrofits to reach appropriate safety levels under new construction requirements covered in other ICC codes.

2012 edition of code establishing regulations involving life and property safety from fires and explosion hazards, including emergency planning, fire department access and water supply, automatic sprinkler systems, fire alarms, and hazardous materials planning and storage.

2012 edition of code establishing minimum regulations for plumbing facilities, including fixtures, water heaters, water supply and distribution, sanitary drainage, storm drainage, etc.

Report describing practices and considerationsfor more efficient water use in pools, spas, and fountains.

Code describing energy codes for energy-conserving and compliant designs in Florida.

The purpose of this standard is to establish minimum requirements to safeguard the public health, safety and general welfare relative to the design, construction and installation of storm shelters constructed for protection from high winds associated with tornadoes and hurricanes.

2015 edition of the code establishing regulations to safeguard life and property from the intrusion of wildland fire and to prevent structure fires from spreading to wildland fuels; regulates defensible space and provides ignition-resistant construction requirements to protect against fire exposure...

2018 edition of code for residential buildings that creates minimum regulations for one- and two-family dwellings of three stories or less, bringing together all building, plumbing, mechanical, fuel gas, energy and electrical provisions for one- and two-family residences.

2018 edition of the code establishing regulations to safeguard life and property from the intrusion of wildland fire and to prevent structure fires from spreading to wildland fuels; regulates defensible space and provides ignition-resistant construction requirements to protect against fire exposure...

A colored map showing seismic zones across the United States, ranging from lowest to highest seismic hazards.

Report assessing and scoring code enforcement and administration and contractor licensing in the 18 states most vulnerable to catastrophic hurricanes along the Atlantic Coast and the Gulf of Mexico.

Code set from IAPMO explaining plumbing standards. 2018 publication.

Document intended to help owners, designers, builders, inspectors, examiners, and energy consultants comply with and enforce California’s energy efficiency standards for low-rise residential buildings (also known as Title 24).

Performance rating standards for unitary air-conditioners and unitary air-source heat pumps, including definitions, classifications, testing, rating, and operating requirements, as well as minimum data requirements for published ratings and markings.

Guidebook covering basic principles and data used in the HVAC&R industry. This is the 2023 edition of the handbook, which can be purchased physically or digitally at the reference link in versions using either I-P units of measurement or SI units of measurement.

State specialty code requiring energy efficiency measures in residential buildings.

Report describing the results of a field study of five different ventilation system types in 29 homes in the Pacific Northwest.

Report describing testing and analysis on deep energy retrofits of existing single-family homes in the U.S.

Technical manual from ACCA outlining correct methods for zoning of residential HVAC systems.

This Standard establishes the minimum requirements to evaluate a residence with regards to energy efficiency, water conservation, occupant comfort, and indoor air quality.

Fact sheet poster describing how to add exterior, continuous, rigid insulation to the exterior walls when replacing siding on an existing home.

Guide describing advanced framing, a system of construction framing techniques designed to optimize material usage and increase energy efficiency.

Report describing two retrofit duct sealing techniques - manually-applied sealants and injecting a spray sealant, that were implemented in several low-rise multi-unit buildings in North Carolina.

Case study about high humidity, mold and condensation on surfaces in S. Florida, and how building characteristics cause and amplify these problems.

This report describes research conducted to evaluate air transfer between the garage and living space in a single-family detached home constructed to the 2009 IECC by a production home builder in Maryland.

Case study examining the problem of unwanted air transfer from garage to living space and the effectiveness of garage exhaust ventilation or house supply ventilation to provide a solution to that.

Article describing how an airtight home shell helps achieve a tight envelope that is energy efficient and cost effective.

This is a federal tax credit for complying air source heat pumpe. Units located in the "North" must meet ENERGY STAR's cold climate heat pump criteria.

Research report describing study of interior and exterior air sealing techniques to stop ice dams in five 1.5-story retrofit homes conducted by the NorthernSTAR Building America Partnership team run by University of Minnesota.

Report outlining workflow and results of regression models on monthly and daily utility data (meter readings of electricity consumption), outlining a process for screening and gathering useful results from inverse models.

Website providing consumers with information about the risk to children from appliances and furniture tipping over and ways to anchor furniture and appliances to prevent this hazard.

Article describing air sealing and air barriers in buildings.

Standard establishing the minimum whole-building energy performance requirements for energy efficient residential buildings.

Technical report describing the evaluation of air management systems in a high-rise apartment building in Toronto, Ontario, focusing on air leakage, suite depressurization, and the performance of in-suite exhaust and corridor ventilation systems.

ASTM standard describing a method for field testing windows, skylights, doors, and curtain walls for water leakage tightness.

Standard establishing test methods for determining air leakage in duct systems using fan pressurization in low-rise residential and commercial buildings.

Website developed by the Attachments Energy Rating Council to provide consumers with credible, relevant, and comparable information about window attachments and their performance.

This report outlines research activities that are expected to facilitate the adoption of energy retrofits by remodeling contractors and roofing contractors using retrofit panels which applicable to many existing house designs in most climates and markets.

Report covering interior energy retrofits of masonry buildings.

Article describing the building science implications of insulating vented or unvented attics.

Article describing the research into insulating vented versus unvented attics.

Information sheet from FEMA on preparation for extreme heat, including measures for keeping homes cool.

Report describing the best practices for the safe, efficient, and compliant installation of residential air source heat pump water heaters (HPWH) in California, aligning with the state's climate goals and providing guidance for educators, installers, and industry stakeholders.

This Best Practices Manual is the product of Hammer & Hand’s ongoing work to document and internally codify our standard operating procedures for construction practice.

Information sheet about reservoir claddings.

Report examining the cost differences between a typical home and a home constructed using wildfire-resistant materials and design features.

Web report explaining how correct filter sizing is an issue that applies to all new and existing homes that use ducted HVAC systems.

Article describing correct ways to eliminate water damage by incorporating a sacrificial layer to foundation walls and footings.