Library

Report on the impact of air sealing between the foundation and the living space on radon transport reduction across the foundation and living space floor assembly at fifteen home.

Fact sheet defining “lowest floor,” identifying common construction practices that are violations of NFIP regulations, and discussing benefits of exceeding the NFIP minimum building elevation requirements; also published in FEMA P-499 “Home Builder’s Guide to Coastal Construction: Technical Fact...

If your kitchen has a powerful exhaust fan, it may be pulling air down your chimney or water-heater flue.

Fact sheet describing important roof-to-wall and wall-to-foundation connection details for masonry construction in coastal areas, including load paths, building materials, and reinforcement; also published in FEMA P-499 “Home Builder’s Guide to Coastal Construction: Technical Fact Sheet Series.”

Siding installation guide for Ply Gem Siding Group products.

This Measure Guideline provides design and construction information for a deep energy enclosure retrofit solution of a flat roof assembly.

Report on two approaches to retrofitting existing double-stud walls.

Report describing a deep energy enclosure retrofit solution for insulating mass masonry buildings from the interior.

Report describing wall assemblies that use layers of rigid exterior insulation thicker than 1-½ inch and require a secondary cladding attachment location exterior to the insulation.

Report describing the use of mineral fiber insulating sheathing in a high performance enclosure retrofit package.

Fact sheet describing practices for minimizing water intrusion through roof vent systems, which can lead to interior damage and mold growth in high-wind regions, including soffit vents, ridge vents, gable end vents, off-ridge vents, gable rake vents, and turbines; also published in FEMA P-499 “Home...

Fact sheet describing how typical wall moisture barrier systems work, the moisture barrier system and common problems associated with them; also published in FEMA P-499 “Home Builder’s Guide to Coastal Construction: Technical Fact Sheet Series.”

Document describing a hygrothermal modeling study, including all of the US climate zones, a range of interior humidity levels and numerous arrangements and types of insulation.

Information sheet about mold mitigation.

Worker guidance from EPA, HUD, NIH, and OSHA on how to deal with mold in homes following natural disasters.

Report on a study monitoring moisture conditions of double-stud wall assemblies with different insulation in Devens, Massachusetts.

Standard covering overs mounting systems, including mounting devices, clamping devices and ground lugs for use with photovoltaic modules and panels and contains requirements for ground-mounted and roof systems as part of a nonstructural building component.

This report is designed to meet ASHRAE 62.2-2010/2013 and ANSI/ACCA’s 5 QI-2015 protocol, thereby improving the performance of HVAC equipment in new homes when compared to homes built to minimum code.

Report describing the interactions, both positive and negative, between common green building practices and the robustness of residential buildings to withstand natural hazards.

Building science insight into crawlspaces.

Standard containing requirements for carbon monoxide (CO) detection and warning equipment intended to protect lives by warning occupants of the presence of CO in sufficient time to allow occupants to escape or take other appropriate action.

Standard providing a procedure for determining fenestration attachment product U-factors.

Standard for determining fenestration attachment product SHGC and visible transmittance.

Fact sheet providing guidance on alternative building materials and techniques in coastal environments, including Engineered Wood Products, SIPs, ICFs, Prefabricated Shear Walls and Moment Frames, Sprayed Closed-Cell Foam Insulation, Advanced Wall Framing, and Modular Houses; also published in FEMA...

Report providing quick reference guide information to help a family prepare for hurricane season, including seven steps to a wind resistant home, a wind inspection checklist, and how to find a contractor.

Study examining how design features, such as building envelope openings and compartmentalization, affect the wind pressure in typical low-rise buildings with gable and hip roofs.

Report highlighting the evaluation methods used and extent of wind washing found in a study analyzing wind washing in thirty-two two-story homes.

Report presenting the results of a study evaluating retrofit solutions for addressing the effects of wind washing on homes.

Standards for paints and coatings.

Paper examining the monitored performance of four newly constructed near zero energy homes in Florida.

Fact sheet describing basic information about pile design and installation, including pile types, sizes and lengths, layout, installation methods, bracing, field cutting, connections, and verifying capacities; also published in FEMA P-499 “Home Builder’s Guide to Coastal Construction: Technical Fact...

Report briefly reviewing past research on the effects of occupant behavior on residential energy use and then covering a two year pilot evaluation of a low cost residential energy feedback system installed in twenty case study homes in Florida.

Document with information about the most practical methods to achieve whole-wall performance of R-30 or above.

This page provides important information on how to protect yourself and your family if you suspect that you might have vermiculite insulation from Libby, Montana.

Fact sheet describing the special considerations that must be made when installing utility equipment, such as fuel, sewage, and water/sewage lines in a coastal home, and presenting recommendations for utility protection; also published in FEMA P-499 “Home Builder’s Guide to Coastal Construction...

Technical fact sheet describing the selection and installation of storm shutters and impact-resistant glazing and other types of opening protection in windborne debris regions; also published in FEMA P-499 “Home Builder’s Guide to Coastal Construction: Technical Fact Sheet Series.”

U.S. Department of Energy's website describing radiant barriers in homes.

Worker guidance from EPA, HUD, NIH, and OSHA for radon issues following a natural disaster.

An example of a form a building codes department created to ensure builders are fully aware and have taken steps to provide drainage so that water doesn’t accumulate behind siding. This example is from the city of Newberg, Oregon.

Report showing how to identify, inventory, and screen buildings that are potentially hazardous because of seismic hazards.

Report providing strategies to support occupant behavior changes for enhancing resilience, and to reduce a building's vulnerability to extreme weather, climate change, and loss of power.

Guide addressing immediate responses for cleaning up after natural disasters, including a list of construction retrofit guidance for natural disasters.

Guide discussing ways that homeowners in ground-secured houses can reduce the risks and damage caused by floods upon residential buildings.

Information sheet describing refrigerant line installation and system startup procedures.

Fact sheet describing an alternative to piles in V Zones and A Zones in coastal areas where soil properties preclude pile installation, but the need for an “open foundation system” still exists and recommendations for good masonry practices in coastal environments; also published in FEMA P-499 “Home...

Webpage from FEMA describing how to properly reconstruct masonry fireplace chimneys damages by earthquakes.

Fact sheet describing NFIP requirements for repairs, remodeling, and additions, and discussing opportunities for retrofitting in coastal flood hazard areas with recommendations for exceeding the minimum NFIP requirements; also published in FEMA P-499 “Home Builder’s Guide to Coastal Construction...

Fact sheet describing requirements and opportunities for retrofitting, and making “best practice” recommendations for repairs, remodeling, and additions in coastal high wind areas; also published in FEMA P-499 “Home Builder’s Guide to Coastal Construction: Technical Fact Sheet Series.”

Presentation providing information about correctly installing ductwork in new and existing homes.