Library

Project discussing buried or encapsulated ducts and their pros and cons.

Report describing the installation and operation of forced-air heating and domestic hot water combi systems in residential homes.

Report providing step-by-step instructions for heating contractors and hydronic designers for selecting the proper control settings to maximize system performance and improve response time when using a thermostat setback.

Report about evaporative condensers, to provide information on a cost-effective solution for energy and demand savings in homes with cooling loads.

Guideline describing information and specifications relevant to air-seal existing attics.

Document covering installation of high efficiency gas furnaces, including when to install a high efficiency gas furnace as a retrofit measure, how to identify and address risks, and steps to follow for the selection and installation process.

Report providing guidance on how to implement a compact duct system inside a plenum truss bulkhead of a one-story, slab-on-grade home.

Report describing the use of passive vents as a source of outdoor air in multifamily buildings.

Document covering the technical aspects of buried and insulated ducts (BEDs), as well as the advantages, disadvantages, and risks of BEDs compared to alternative strategies.

Report describing the sealing and insulating of HVAC duct systems in existing homes.

This document addresses adding—or improving—mechanical ventilation systems to existing homes. The purpose of ventilation is to remove contaminants from homes either directly or by dilution. This report discusses where, when, and how much ventilation is appropriate in a home, including some...

Document intending to put some context and structure around the process of balancing and tuning one-pipe steam systems to help practitioners begin to garner the potential in energy savings that this measure presents.

Document illustrating guidelines for efficient installation of interior duct systems in new housing.

Guide describing proper application, design, and installation of mechanical ventilation cooling systems for homes located in hot-dry and cold-dry climates, as well as a means of understanding the benefits, costs, and tradeoffs of these systems.

Report describing the most cost-effective ventilation and indoor air quality solutions for multifamily homes that meet ASHRAE 62.2-2016.

Research study analyzing measured energy savings from a moderate retrofit by comparing post-retrofit performance with measured pre-retrofit monitored data.

Research study outlining results of monitoring a low temperature heat pump.

Web resource that lays out the pre-work considerations, methods and finishes for installing mechanical insulation.

Standard that prescribes a testing method to determine the efficiency of space heating and/or cooling thermal distribution systems under seasonal and design conditions. This version of the standard was published in the year 2014, and is available for preview and purchase at the reference link. The...

Standard establishing a test procedure for evaluating the performance of air-cleaning devices as a function of particle size. This is the current version of the standard, which was published in the year 2017, and is available for preview and purchase at the reference link. The ASHRAE bookstore also...

Report covering the selection of roof vents for rainwater resistance.

FEMA report describing findings from an investigation of Hurricane Ike in Texas and Louisiana and residential construction recommendations based on those findings.

FEMA Mitigation Assessment Team Report describing damages from Hurricane Michael in Florida in Oct. 2018 and recommendations for future hurricane preparedness.

Book with indepth information about hydronic systems for residential and commercial buildings.

Report on the use of vapor diffusion ports to reduce moisture issues with buried ductwork in unvented attics in hot-humid climates.

Conference paper making the case that moving ducts to conditioned space saves energy, is practical for production builders (when accompanied by careful pre-planning), and creates significant andmarketable energy savings for homebuyers.

This report is designed to meet ASHRAE 62.2-2010/2013 and ANSI/ACCA’s 5 QI-2015 protocol, thereby improving the performance of HVAC equipment in new homes when compared to homes built to minimum code.

Database compiling extended capacity data for numerous cold climate heat pump manufacturers and models.

Report discussing the benefits of modern evaporative cooling systems for use in hot dry climate zones.

Guide providing information on controlling attic ductwork sweating.

Document on the development of two simple in-home efficiency test methods that can be used by technicians, researchers, or interested homeowners to verify the correct operation and energy efficiency of a homes air conditioning and heating equipment.

Document about development of recommendations to help residential HVAC designers select optimal supply inlet size and system operating conditions to maintain good thermal comfort in low heating and cooling load homes.

Report highlighting the evaluation methods used and extent of wind washing found in a study analyzing wind washing in thirty-two two-story homes.

Research study using modeling to determine optimal combination(s) of components/pumps, high efficiency heat sources, plumbing configurations and controls that result in the highest overall efficiency for a hydronic system.

Report providing information to researchers, utility program managers, and building owners interested in controlling heating energy waste and improving resident comfort.

Article investigating how a linear input/output relationship can be used as a simple model of the performance of a combination hydronic heating system over heating only, DHW only, and combined loads.

Article outlining moisture accumulation in open cell spray polyurethane foam.

Information sheet providing guidance about the placement of ventilation approaches.

Article describing how to properly manage condensing HVAC equipment.

Article describing how ice dams form on residential roofs, how they damage homes, and solutions to prevent future dams.

This page provides important information on how to protect yourself and your family if you suspect that you might have vermiculite insulation from Libby, Montana.

Website from the EPA containing information for homeowners and renters about how to identify asbestos in the home and how to deal with it to reduce exposure to it.

Guide describing flood protection measures for utility systems, including mechanical, electrical, plumbing, and fuel.

Website providing an online calculator for determining energy and cost savings from installing radiant barriers in attics.

Fact sheet describing analysis of potential heating and cooling savings from radiant barriers in attics.

U.S. Department of Energy's website describing radiant barriers in homes.

Website with answers to some of the most commonly asked questions about attic radiant barriers.

Document with important building science considerations, designed for members of the residential construction and remodeling industries, as well as owners and managers who work in affordable housing.

Information sheet designed for the residential construction and remodeling industries, as well as owners and managers working in affordable housing. This sheet presents building guidance for both new construction and rehabilitation, as well as practices that can be used by property maintenance...

Research project aimed to verify whether homes in the New Jersey HPwES program achieved 30% source energy savings, and if so, what measures were implemented to achieve them.