Library

Web article describing common issues that can cause refrigerant system flare joints to leak.

2009 edition of code establishing minimum regulations for plumbing facilities, including fixtures, water heaters, water supply and distribution, sanitary drainage, storm drainage, etc.

2012 edition of code establishing minimum regulations for plumbing facilities, including fixtures, water heaters, water supply and distribution, sanitary drainage, storm drainage, etc.

Document describing the air leakage provisions of Appendix RA of the 2015 IECC (prepared for the State of Georgia to assist with compliance with their 2019 Energy Code).

2015 edition of code establishing minimum regulations for plumbing facilities, including fixtures, water heaters, water supply and distribution, sanitary drainage, storm drainage, etc.

2018 edition of code establishing minimum regulations for plumbing facilities, including fixtures, water heaters, water supply and distribution, sanitary drainage, storm drainage, etc.

Report describing how changing the air exchange rate of a home (the sum of the infiltration and mechanical ventilation airflow rates) affects the annual thermal conditioning energy.

Standards book discussing the minimum standards of total system balance of HVAC systems.

Standard providing master specifications for closed cell, medium density spray polyurethane foam air barriers located in the non-accessible part of the wall.

Standard outlining materials and installation methods by using commercial building wraps.

Standard providing information about self-adhered sheet air barriers located in the non-accessible part of the wall and materials to bridge and seal air leakage pathways and gaps.

Standard outlining materials and installation methods for a liquid-applied vapor permeable air barrier systems located in the non-accessible part of the wall.

Vinyl siding estimating and installation guide for vinyl siding products.

Standard covering equipment sizing loads for single-family-detached homes, small multi-unit structures, condo­miniums, town houses and manufactured homes.

Technical manual from ACCA outlining correct methods for zoning of residential HVAC systems.

A website explaining the process of sealing a home with Aeroseal & how the technology is used to seal holes in the air ducts and vents of the home.

Report examining the effectiveness of an aerosolized acrylic technique for air sealing existing homes to reduce air leakage and improve energy efficiency.

Technical report describing the research behind a new aerosol-based sealing method, utilizing pressurization and a dispersed sealant fog, facilitated by a standard blower door, to automatically measure, locate, and seal air leaks in new homes in the United States, providing an efficient solution to...

Fact sheet describing an innovative aerosol-based sealing technique for tightening building envelopes in new homes, involving pressurizing the structure and dispersing an aerosol sealant "fog" to autonomously identify and seal leaks, with real-time feedback through a standard blower door and laptop...

Brochure about creating an air barrier by sealing drywall assemblies.

Brochure about creating an air barrier at tub, shower and fireplace walls.

Information on the control of air flow across building enclosures to control moisture damage, reduce energy losses, and ensure occupant comfort and health. A continuous, strong, stiff, durable and air impermeable air barrier system is required between the exterior and conditioned space to control...

Document reporting results from a study done to evaluate effects of automotive emissions from attached garages on the indoor environment.

Fact sheet describing air-sealing concerns and remedies, including HRV/ERV installation, caulking, spray foam, and weatherstrip installation.

Article describing how an airtight home shell helps achieve a tight envelope that is energy efficient and cost effective.

Article describing how to stop air leaks around the windows and doors of a home.

Website article interviewing the inventor of the Larsen truss, a history of its use, and a discussion of its advantages and disadvantages.

Article about different types of weather resistant barrier.

Report analyzing design heating load sizing methods for superinsulated homes in cold climates and comparing them to the actual energy usage to determine if the building load calculation methodology should be changed for calculating the design heating load of these homes.

Article describing air sealing and air barriers in buildings.

Technical report describing the thermal performance of 40 common building envelope details for mid- and high-rise buildings, including analyses to optimize energy efficiency and reduce thermal bridging.

ASTM standard providing test methods for determining duct air leakage in low-rise residential and commercial buildings.

Article describing how demand plumbing systems send cold water back to the water heater until hot water arrives at the sink, shower or other fixture where it is needed.

Case study describing solar thermal and photovoltaic systems in new construction.

Code establishing the rules of safety relating only to pressure integrity for the design, fabrication, and inspection of boilers and pressure vessels during construction which was published in the year 2017 and is available to order at the referenced link.

Code establishing the rules of safety relating only to pressure integrity for the design, fabrication, and inspection of boilers and pressure vessels during construction which was published in the year 2021 and is available to order at the referenced link.

Document focusing on the design and wall components that contribute to a pressure equalized rain screen wall, including the frequency of the weep holes and other brick masonry rain screen wall requirements.

Case study describing solar thermal and photovoltaic systems in new construction.

Case study describing solar thermal and photovoltaic systems in new construction.

Report comparing a variety of roof insulating strategies to present their advantages and disadvantages according to several comparison criteria.

Website with consumer and contractor information about building codes and regulations for solar water heating systems.

Guide describing methodologies for assessing and mitigating thermal bridging in building envelopes, featuring detailed performance data, interface solutions, and assembly-specific strategies for energy-efficient construction.

Training manual on how to locate ducts within conditioned space and compact design.

Report describing strategies to improve the aging steam heating systems in New York City to improve energy efficiency, reduce oil and gas usage, and cut maintenance costs.

Report outlining how conditioned crawlspaces perform better than vented crawlspaces in terms of safety, health, comfort, durability and energy consumption.

Document presenting step-by-step process for installing rigid insulating sheathing over wood studs or house wrap.

Report exploring alternative methods to find long-term solutions to energy loss in 1 ½-story homes to save energy, improve comfort, prevent frost buildup on the underside of the roof deck, and reduce the risk of ice dam formation/reformation.

Report describing the monitored long-term performance of two solar domestic water heating systems in northern climates.

Website providing lists of WaterSense-qualified products for home plumbing and irrigation equipment that meet the requirements of the U.S. Environmental Protection Agency’s (EPA’s) WaterSense program.

Report outlining the issues with using existing ducts with a new low-load HVAC system, which reduces throw at supply registers causing decreased mixing of supply and room air, leading to potential thermal comfort complaints.