Library

2009 edition of code establishing minimum regulations for plumbing facilities, including fixtures, water heaters, water supply and distribution, sanitary drainage, storm drainage, etc.

2012 edition of code establishing minimum regulations for plumbing facilities, including fixtures, water heaters, water supply and distribution, sanitary drainage, storm drainage, etc.

Code set from IAPMO explaining plumbing standards. 2018 publication.

Case study about high humidity, mold and condensation on surfaces in S. Florida, and how building characteristics cause and amplify these problems.

Research report describing study of interior and exterior air sealing techniques to stop ice dams in five 1.5-story retrofit homes conducted by the NorthernSTAR Building America Partnership team run by University of Minnesota.

Article describing correct ways to eliminate water damage by incorporating a sacrificial layer to foundation walls and footings.

This case study describes costs associated with the External Thermal and Moisture Management System developed by the NorthernSTAR Building America Partnership for retrofitting roofs with rigid foam over the roof deck, especially on one and a half-story homes.

Handbook to help property owners understand the rules, procedures, standards, and criteria that apply to the environmental resource permit (ERP) program under Part IV of Chapter 373 of the Florida Statutes.

Factsheet describing steps builders should take to reduce erosion and control sediment on construction sites during home construction.

Case study describing novel technique for installing exterior spray foam on foundation walls that uses high-pressure water sprayer and a “hydro vac” to remove dirt along the foundation wall.

Research report assessing the moisture and cooling load impacts of airtightness and mechanical ventilation in homes in hot-humid climates.

Web article discussing the primary approaches to waterproofing concrete foundations.

PDF detailing the inspection and verification guidance for WaterSense labeled new homes including indoor and outdoor efficiency requirements, and homeowner and building management education.

Measure Guideline research report providing simple, long term, and durable solutions when using tapes and flashing membranes in conjunction with the exterior face of rigid polymeric foam sheathing to create the drainage plane of a wall system.

Case study about how to properly tape insulating sheathing drainage planes.

An NFPA standards document that provides minimum requirements for the design, construction, installation, and maintenance of tanks and accessory equipment that supply water for private fire protection.

Case study describing the External Thermal and Moisture Management System developed by the NorthernSTAR Building America Partnership for retrofitting roofs with rigid foam over the roof deck, especially on one and a half-story homes.

Resource to help builders better understand the WaterSense requirements for labeled homes and assist them in meeting the criteria so they can receive the label for their new construction.

Fact sheet describing water management in a residential building.

Article describing a method for flashing roof vent boots, describing how to flash the pipe, how to flash over and under the pan, and finish by shaping the shingles, as well as addressing potential water leakage by adding an additional seal with EPDM flashing tape with a butyl adhesive backing to the...

Resource that provides a checklist of program criteria for water-efficient new homes under the U.S. Environmental Protection Agency’s (EPA’s) WaterSense program.