Skip to main content

Showing 1 - 10 of 10 results:

Publication Date
·
Author(s)
International Code Council
·
Organization(s)
ICC
Description
2009 edition of code establishing minimum regulations for plumbing facilities, including fixtures, water heaters, water supply and distribution, sanitary drainage, storm drainage, etc.
Publication Date
·
Author(s)
International Code Council
·
Organization(s)
ICC
Description
2012 edition of code establishing minimum regulations for plumbing facilities, including fixtures, water heaters, water supply and distribution, sanitary drainage, storm drainage, etc.
Publication Date
·
Author(s)
International Association of Plumbing and Mechanical Officials
·
Organization(s)
IAPMO
Description
Code set from IAPMO explaining plumbing standards. 2018 publication.
Publication Date
·
Author(s)
Bill Zoeller
·
Organization(s)
Steven Winter Associates
Description
Web article discussing the primary approaches to waterproofing concrete foundations.
Publication Date
·
Author(s)
National Fire Protection Association
·
Organization(s)
NFPA
Description
An NFPA standards document that provides minimum requirements for the design, construction, installation, and maintenance of tanks and accessory equipment that supply water for private fire protection.
Publication Date
·
Author(s)
U.S. Department of Housing and Urban Development,
Partnership for Advancing Technology in Housing,
National Association of Home Builders
·
Organization(s)
HUD,
PATH,
NAHB Research Center
Description
Report describing how to construct a frost protected shallow foundation (FPSF) as a practical alternative to a deeper, more-costly foundation in cold regions with seasonal ground freezing and the potential for frost heave.
Publication Date
·
Author(s)
Guertin Mike
·
Organization(s)
Fine Homebuilding Magazine
Description
Article describing a method for flashing roof vent boots, describing how to flash the pipe, how to flash over and under the pan, and finish by shaping the shingles, as well as addressing potential water leakage by adding an additional seal with EPDM flashing tape with a butyl adhesive backing to the...