Library

Report about City of Meriden Housing Authority's (MHA) collaboration with Jonathon Rose Companies to complete a gut renovation of 126 residential units in the Chamberlain Heights retrofit project.

Part I of the Guide addresses walls constructed with 2x6 wood frame studs, wood structural panel (WSP) sheathing as exterior sheathing, gypsum board as interior sheathing, and a cladding system installed over WSP sheathing in low-rise residential buildings up to three stories in height.

The Guide addresses walls constructed with 2x4 wood frame studs, wood structural panel (WSP) sheathing as wall bracing and added backing for foam sheathing, a layer of rigid foam sheathing insulation up to 1.5 in. thick over the WSP, and a cladding system installed over the foam sheathing in low...

Report about the Advanced Envelope Research effort will provide factory homebuilders with urgently-needed, cost effective methods for meeting emerging energy code requirements.

Expert Meeting about interior insulation retrofit of mass masonry wall assemblies held on July 30, 2011.

Research study evaluating the dynamic heat transmission characteristics through two identical Insulating Concrete Form (ICF) wall assemblies in Ottawa, Canada.

A guide for designers, architects, engineers, and fire experts on how to design rainscreen and ventilated cavities such that they don’t contribute to the spread of a fire.

Journal article describing lessons learned from updating a 16-year-old deep-energy retrofit.

Research study presenting results of an existing home monitoring project designed to measure wall cavity moisture characteristics.

Report covering control of hydrostatic pressure in wall assemblies.

Report covering reservoir claddings, back ventilation and vapor throttles.

Information sheet providing information on installing Rigid XPS foam board insulation to existing brick masonry walls.

Report summarizing the importance of properly insulating and air sealing masonry walls, providing step by step instructions and approaches.

Document providing renovators and retrofit contractors an overview of considerations when including wall air sealing and insulation in an energy retrofit project.

Report describing the work conducted for high performance hybrid assemblies.

Document about development of models for evaluating thermal performance of walls in existing homes that will improve the accuracy of building energy simulation tools when predicting potential energy savings of existing homes.

Report covering wind loading on roofing assemblies.

Fact sheet describing design and construction practices to reduce the likelihood of water intrusion in walls and foundations in residential construction.

Report covering the reconstruction of flood damaged homes.

Report covering coating and back venting wood based claddings and trim.

Conference paper describing testing of the performance of fasteners used to attach rigid foam insulation to the exterior of walls.

Projectile missile testing of various wall panel configuration to understand how the different wall constructions would perform when struck with wind driven debris from a hurricane.

Article describing the evolution of the IRC to permit class 3 vapor retarders (latex paint) in walls coupled with exterior continuous insulation to allow drying and reduce condensation risk.

Report summarizing NRELs efforts to develop diagnostic test cases to conduct accurate energy simulations when phase change materials (PCMs) are modeled in residential buildings.

An article describing a way to protect drain and ventilation holes in brick veneer siding against pests. Selecting a fine screen mesh opening (1/55-inch or 0.5-mm) is important to guard against small insects such as subterranean termites.

Report describing the design and construction of a highly energy efficient community of ten duplexes in Greenfield, Massachusetts.