Library

Article describing how ice dams form on residential roofs, how they damage homes, and solutions to prevent future dams.

Fact sheet from Wisconsin Focus on Energy explaining how to prevent future ice dams on homes by learning about their formation and mitigation of contributing factors.

Case study describing the External Thermal and Moisture Management System developed by the NorthernSTAR Building America Partnership for retrofitting roofs with rigid foam over the roof deck, especially on one and a half-story homes.

List of recommendations from IBHS on how to protect homes from ice dam formation.

Website providing an online calculator for determining energy and cost savings from installing radiant barriers in attics.

Fact sheet describing analysis of potential heating and cooling savings from radiant barriers in attics.

U.S. Department of Energy's website describing radiant barriers in homes.

Website with answers to some of the most commonly asked questions about attic radiant barriers.

An example of a form a building codes department created to ensure builders are fully aware and have taken steps to provide drainage so that water doesn’t accumulate behind siding. This example is from the city of Newberg, Oregon.

Report covering the performance of residential buildings during three hurricanes impacting Florida in 2004.

Information sheet with the definition and uses for a raised truss.

Searchable database of over 3,000 roofing products that have undergone solar reflectance and thermal emittance testing.

Technical report describing the Re-Side Right initiative by the New Jersey Institute of Technology's Building America research team that proposes enhancing home efficiency during the re-siding process by incorporating an insulating layer that acts as both an air barrier and water resistive barrier...

Fact sheet describing conditions for wildfire, how a home catches fire, how to create a survivable space, the ideal fire resistant home.

Webpage explaining how to mitigate heat loss through roofs for ice dam prevention.

A report presenting alternative approaches for reducing the costs of roof-mounted, grid-connected photovoltaic (PV) systems.

An EPA guide describing the causes and impacts of summertime urban heat islands, promoting strategies for lowering temperatures in U.S. communities.

Article describing moisture and ice dam issues in attics and how to air seal the attic floor.

Webpage from FEMA describing how to properly reconstruct masonry fireplace chimneys damages by earthquakes.

Report providing architects, designers, and homeowners with information to make house plans useful for constructing a more wind resilient structure.

Report describing the testing of various siding materials for their ability to resist bullets from small firearms.

Fact sheet describing how to install bracing to retrofit roof dormers for increased wind resistance.

Factsheet providing homeowners with an overview of approaches for flashing and sealing roof penetrations to help discussion with a roofing contractor.

Fact sheet describing flashing of roof penetrations to make a home more resistant to high winds, hurricanes, and rainwater intrusion.

Report covering non-combustible continuous exterior insulation and non-combustible roof venting.

Fact sheet describing proper roof sheathing installation and illustrating fastening methods that will enhance the durability of a building in high-wind areas; also published in FEMA P-499 “Home Builder’s Guide to Coastal Construction: Technical Fact Sheet Series.”

Fact sheet describing recommended practices for the use of roofing underlayment as an enhanced secondary water barrier in coastal environments and optional installation methods; also published in FEMA P-499 “Home Builder’s Guide to Coastal Construction: Technical Fact Sheet Series.”

Q&A article discussing how to address moisture issues in an attic in a wet and humid coastal climate.

Fact sheet describing the importance of proper roof and deck flashing, and typical and enhanced flashing techniques for coastal homes; also published in FEMA P-499 “Home Builder’s Guide to Coastal Construction: Technical Fact Sheet Series.”

Webpage discussing the characteristics of sunlight and how cool roofs work to reduce solar heat gain.

Website providing the pros and cons of different siding materials for home building, including wood, vinyl, fiber cement, stucco, brick, metal, and stone.

Fact sheet describing building envelope performance measures applicable to residential and small commercial construction.

Report informing building stakeholders about the risks a snow event poses to their buildings, preventative measures to take before the snow season, and actions that should be taken before, during, and after a snow event.

Webpage providing information about design snow loads and a free interactive ground snow load mapping tool for the contiguous United States, as well as snow load calculation methods.

Specifications to assist builders in designing and constructing homes equipped with a set of features that make the installation of solar energy systems after the completion of the home’s construction easier and less expensive.

Manual describing the installation process for Craneboard insulated vinyl siding; while installation is similar across insulated vinyl siding products, see manufacturers for specific guidance.

Spreadsheet tool that computes solar reflectance index (SRI) and roof surface temperature based on solar reflectance and thermal emittance using ASTM standard E 1980.

Specification describing criteria for manufactured polymeric materials used to provide a rainscreen function, a means for the drainage of liquid moisture and the ventilation of vapor moisture that enters an above-grade exterior wall assembly which was published in the year 2019, and is available for...

Article describing ways to protect roofs from water infiltration by using self-adhering underlayment in vulnerable locations such as roof valleys, eave edges (to help deal with ice dams), rake edges, roofs to vertical walls (such as dormers), sidewall protection, the bottom of dormer valleys, and...

Report covering coating and back venting wood based claddings and trim.

Fact sheet describing water management in a residential building.

A story about bees building a hive in the drainage plane behind the brick veneer siding. The bees entered the wall through unprotected drainage holes.

Fact sheet describing the test procedure for wind and wind driven rain resistance of discontinuous roofing systems.

Projectile missile testing of various wall panel configuration to understand how the different wall constructions would perform when struck with wind driven debris from a hurricane.

Manuals describing design, materials, and installation techniques applicable to almost all types of roof systems; four-volume set includes Metal Panel and SPF Roof Systems, Membrane Roof Systems, Architectural Metal Flashing and Condensation and Air Leakage Control, and Steep-Slope Roof Systems.

Article from Purdue University on the potential for white paint technology to lower air conditioning usage requirements.

Factsheet providing design guidance for engineers describing how to characterize snow drifts on roofs in three dimensions rather than two, as anticipated in the 2022 edition of the standards, ASCE 7 - Minimum Design Loads and Associated Criteria for Buildings and Other Structures.

Fact sheet outlining best design and construction practices for tile roofing in high wind areas; also published in FEMA P-499 “Home Builder’s Guide to Coastal Construction: Technical Fact Sheet Series.”

Report presenting information that aids qualified architects and engineers in the identification of the best available refuge areas in existing buildings for sheltering in place during a tornado.

Webpage from Southern California Earthquake Center (SCEC) on identifying key problem spots on unreinforced masonry chimneys and how to retrofit them to withstand seismic forces.