Library

A user forum discussing ways to reinforce a gable overhand that was framed using the ladder method by Mike Mahan.

Webpage from FEMA describing how to properly reconstruct masonry fireplace chimneys damages by earthquakes.

Table in the IRC describing bracing requirements for specified wind speeds and building story locations.

A fact sheet educating homeowners on the importance of residential safe rooms, including their cost and how to register a safe room with local officials.

Report providing architects, designers, and homeowners with information to make house plans useful for constructing a more wind resilient structure.

Report describing the testing of various siding materials for their ability to resist bullets from small firearms.

Fact sheet describing how to install bracing to retrofit roof dormers for increased wind resistance.

A brochure educating homeowners on how to install self-locking devices on cabinets, drawers and doors, including child-proof latches and drawer locks.

Factsheet providing homeowners with an overview of approaches for flashing and sealing roof penetrations to help discussion with a roofing contractor.

Fact sheet describing flashing of roof penetrations to make a home more resistant to high winds, hurricanes, and rainwater intrusion.

Report describing extensive renovations to a historic home.

Report covering non-combustible continuous exterior insulation and non-combustible roof venting.

Fact sheet describing proper roof sheathing installation and illustrating fastening methods that will enhance the durability of a building in high-wind areas; also published in FEMA P-499 “Home Builder’s Guide to Coastal Construction: Technical Fact Sheet Series.”

Fact sheet describing recommended practices for the use of roofing underlayment as an enhanced secondary water barrier in coastal environments and optional installation methods; also published in FEMA P-499 “Home Builder’s Guide to Coastal Construction: Technical Fact Sheet Series.”

Q&A article discussing how to address moisture issues in an attic in a wet and humid coastal climate.

Fact sheet describing the importance of proper roof and deck flashing, and typical and enhanced flashing techniques for coastal homes; also published in FEMA P-499 “Home Builder’s Guide to Coastal Construction: Technical Fact Sheet Series.”

Factsheet from HUD describing how to properly rebuild following natural disasters in Puerto Rico.

Factsheet from HUD describing how homeowners can retrofit homes following natural disasters in the U.S. Virgin Islands.

Factsheet from HUD describing how to rebuild following natural disasters in Puerto Rico.

Factsheet for builders from HUD on how to rebuild homes following natural disasters in the U.S. Virgin Islands.

Report covering the planning, design, construction, and operation of residential and community safe rooms. Written for architects, engineers, building officials, local officials and emergency managers, and prospective safe room owners and operators.

Webpage discussing the characteristics of sunlight and how cool roofs work to reduce solar heat gain.

Report promoting public safety and welfare by reducing the risk of earthquake-induced damage to existing homes.

Report promoting public safety and welfare by reducing the risk of earthquake-induced damage to existing homes.

Fact sheet describing building envelope performance measures applicable to residential and small commercial construction.

Technical report providing site selection guidance for installation of small wind turbines.

Report informing building stakeholders about the risks a snow event poses to their buildings, preventative measures to take before the snow season, and actions that should be taken before, during, and after a snow event.

Webpage providing information about design snow loads and a free interactive ground snow load mapping tool for the contiguous United States, as well as snow load calculation methods.

Specifications to assist builders in designing and constructing homes equipped with a set of features that make the installation of solar energy systems after the completion of the home’s construction easier and less expensive.

Spreadsheet tool that computes solar reflectance index (SRI) and roof surface temperature based on solar reflectance and thermal emittance using ASTM standard E 1980.

Standard document establishing construction standards for one- and two-family dwellings constructed in high wind regions.

A website providing timely and accurate forecasts and watches for severe thunderstorms and tornadoes over the contiguous United States.

Article describing ways to protect roofs from water infiltration by using self-adhering underlayment in vulnerable locations such as roof valleys, eave edges (to help deal with ice dams), rake edges, roofs to vertical walls (such as dormers), sidewall protection, the bottom of dormer valleys, and...

Report recommending strategies and approaches that the Federal government and other stakeholders may take to encourage and aid States and local communities in the adoption of the most current building codes.

Article describing three ways to strengthen the roof-to-wall connections in an existing home.

Article defining structural design loads and ways to calculate them, including dead loads, live loads, soil lateral loads, wind loads, snow loads, earthquake loads, and other loads.

Recovery advisory presenting key wind retrofit guidelines for buildings located in hurricane-prone regions. These retrofit guidelines are intended to help building owners and designers prevent or limit wind damage and water infiltration during high-wind events.

Article describing suggested food supplies, sanitation, safety, and cooking for during and after an emergency.

Presentation by the Washington University in St. Louis Office of Sustainability on saving energy.

A guide for homeowners on determining the risks from tornadoes and hurricanes and selecting a safe room type and location, as well as providing detailed plans for safe room construction.

Report presenting safe room designs and showing the homeowner and builder/contractor or local design professional how to construct a safe room for a home or small business.

Fact sheet describing water management in a residential building.

Fact sheet describing the test procedure for wind and wind driven rain resistance of discontinuous roofing systems.

Fact sheet providing the wind resistant provisions of the 2015 International Residential Code.

Projectile missile testing of various wall panel configuration to understand how the different wall constructions would perform when struck with wind driven debris from a hurricane.

Report illustrating CAD drawings and modeling of bracing layouts for a gable roof truss.

Report descrbing an early study pointing to the significant improvement, >50%, of a hip roof in reducing peak wind-induced pressures.

Manuals describing design, materials, and installation techniques applicable to almost all types of roof systems; four-volume set includes Metal Panel and SPF Roof Systems, Membrane Roof Systems, Architectural Metal Flashing and Condensation and Air Leakage Control, and Steep-Slope Roof Systems.

A book describing seismic retrofits to help contractors and engineers understand how to properly retrofit a home in a cost-effective manner.

Guide describing details that serve as a visual reference for each of the line items in the Thermal Enclosure System Rater Checklist.