Library

Report describing research efforts focused on examining the audit reports for quality, comprehensiveness, and consistency.

Fact sheet describing how to install bracing to retrofit roof dormers for increased wind resistance.

Factsheet providing homeowners with an overview of approaches for flashing and sealing roof penetrations to help discussion with a roofing contractor.

Fact sheet describing flashing of roof penetrations to make a home more resistant to high winds, hurricanes, and rainwater intrusion.

Report about a tool developed to enable users to compare a typical 1970s ranch home against an IECC 2009 code-compliant home of the same configuration and against the 70s base case plus retrofits.

Information sheet describing solar PV upgrade for an existing homes.

Information sheet describing tankless hot water heating systems in existing homes.

Information sheet describing solar hot water systems in existing homes.

Information sheet about envelope and roof moisture control retrofit for a home.

Report covering non-combustible continuous exterior insulation and non-combustible roof venting.

Fact sheet describing proper roof sheathing installation and illustrating fastening methods that will enhance the durability of a building in high-wind areas; also published in FEMA P-499 “Home Builder’s Guide to Coastal Construction: Technical Fact Sheet Series.”

Fact sheet describing recommended practices for the use of roofing underlayment as an enhanced secondary water barrier in coastal environments and optional installation methods; also published in FEMA P-499 “Home Builder’s Guide to Coastal Construction: Technical Fact Sheet Series.”

Q&A article discussing how to address moisture issues in an attic in a wet and humid coastal climate.

Fact sheet describing the importance of proper roof and deck flashing, and typical and enhanced flashing techniques for coastal homes; also published in FEMA P-499 “Home Builder’s Guide to Coastal Construction: Technical Fact Sheet Series.”

Webpage discussing the characteristics of sunlight and how cool roofs work to reduce solar heat gain.

Technical study exploring the impact of different installation faults on heat pump performance in a single-family house.

Report summarizing commissioning, short-term testing, and analysis that occurred before, during, and just after the actual retrofit of the Bay Ridge project.

Fact sheet describing building envelope performance measures applicable to residential and small commercial construction.

Paper describing the development and testing of an affordable net-zero energy house in Lenoir City, Tennessee.

Webpage describing the STEP campaign encouraging the use of smart diagnostic tools to reduce installation faults.

Report informing building stakeholders about the risks a snow event poses to their buildings, preventative measures to take before the snow season, and actions that should be taken before, during, and after a snow event.

Webpage providing information about design snow loads and a free interactive ground snow load mapping tool for the contiguous United States, as well as snow load calculation methods.

Specifications to assist builders in designing and constructing homes equipped with a set of features that make the installation of solar energy systems after the completion of the home’s construction easier and less expensive.

Research study presenting a unique opportunity to both identify and evaluate deep retrofit measures that are practical and potentially cost effective for the retrofit market, as well as review the cost effectiveness of the Passive House design approach for achieving energy savings in deep retrofits.

Spreadsheet tool that computes solar reflectance index (SRI) and roof surface temperature based on solar reflectance and thermal emittance using ASTM standard E 1980.

Article describing ways to protect roofs from water infiltration by using self-adhering underlayment in vulnerable locations such as roof valleys, eave edges (to help deal with ice dams), rake edges, roofs to vertical walls (such as dormers), sidewall protection, the bottom of dormer valleys, and...

Document identifying differences between the requirements for construction documents for high performance housing and the documents that are typically produced for conventional housing.

Report intending to provide useful information as the DOE/BA develops and implements comprehensive communications and outreach strategies for demonstration homes.

Document serving as a starting point that features initial tools and resources for teams to start collaborating to continually improve the energy efficiency and durability of new houses.

Research study providing a comparison of selected retrofit activity typically done, versus that same retrofit activity approached from an integrated high performance remodeling and quality management perspective.

Research study determining how well high performance envelope and innovative cooling system interact to cost effectively reduce cooling energy use in this hot-dry climate.

Research study making several recommendations to whole-home program designers and implementers for improving the cost effectiveness and reach of whole-home programs.

Report evaluating a test home built in Atlanta, GA in the mixed-humid climate zone. The report outlines the features of the house, discusses the implementation of the energy efficient design, and presents the results of short-term characterization testing.

This guide and workbook offers practitioners with the knowledge to properly implement the measurement and documentation procedures required in the ANSI/ACCA 5.

Fact sheet describing water management in a residential building.

Report using data from various sources to characterize the impact on human health and property damage from indoor environmental quality and other hazards.

Fact sheet describing the test procedure for wind and wind driven rain resistance of discontinuous roofing systems.

Manuals describing design, materials, and installation techniques applicable to almost all types of roof systems; four-volume set includes Metal Panel and SPF Roof Systems, Membrane Roof Systems, Architectural Metal Flashing and Condensation and Air Leakage Control, and Steep-Slope Roof Systems.

Report developed for Habitat for Humanity about lessons learned from demonstration retrofit projects undertaken by Habitat for Humanity affiliates in New York, Maryland, and Pennsylvania; with building systems consulting and technical assistance provided by Steven Winter Associates.

Report presenting results from whole-house monitoring efforts in hope that they may be useful for others moving towards zero energy homes.

Article from Purdue University on the potential for white paint technology to lower air conditioning usage requirements.

Factsheet providing design guidance for engineers describing how to characterize snow drifts on roofs in three dimensions rather than two, as anticipated in the 2022 edition of the standards, ASCE 7 - Minimum Design Loads and Associated Criteria for Buildings and Other Structures.

Fact sheet outlining best design and construction practices for tile roofing in high wind areas; also published in FEMA P-499 “Home Builder’s Guide to Coastal Construction: Technical Fact Sheet Series.”

Report presenting information that aids qualified architects and engineers in the identification of the best available refuge areas in existing buildings for sheltering in place during a tornado.

Case study about affordable housing in a mixed, humid climate.

Webpage from Southern California Earthquake Center (SCEC) on identifying key problem spots on unreinforced masonry chimneys and how to retrofit them to withstand seismic forces.

Report reviewing unvented roof assemblies, such as conditioned attics and unvented cathedral ceilings that are becoming common in North American construction.

Document summarizing the various papers on unvented conditioned cathedralized attics found on BSC's website.

Report covering wind uplift and roofing membrane failures.

Webpage describing the use of cool roofs to reduce heat islands and and benefits and costs.