Library

Web article describing common issues that can cause refrigerant system flare joints to leak.

2009 edition of code establishing minimum regulations for plumbing facilities, including fixtures, water heaters, water supply and distribution, sanitary drainage, storm drainage, etc.

2012 edition of code establishing minimum regulations for plumbing facilities, including fixtures, water heaters, water supply and distribution, sanitary drainage, storm drainage, etc.

Code describing energy codes for energy-conserving and compliant designs in Florida.

2015 edition of code establishing minimum regulations for plumbing facilities, including fixtures, water heaters, water supply and distribution, sanitary drainage, storm drainage, etc.

2018 edition of code establishing minimum regulations for plumbing facilities, including fixtures, water heaters, water supply and distribution, sanitary drainage, storm drainage, etc.

Article describing methods for thermally isolating a garage in a Passive House-certified multifamily building.

Vinyl siding estimating and installation guide for vinyl siding products.

Radiant, hydronics, geothermal -- they are a vital part of modern comfort and energy solutions. ACCA helps hydronics contractors operate at peak performance.

Guide describing advanced framing, a system of construction framing techniques designed to optimize material usage and increase energy efficiency.

Fact sheet describing air-sealing concerns and remedies, including HRV/ERV installation, caulking, spray foam, and weatherstrip installation.

Article describing how demand plumbing systems send cold water back to the water heater until hot water arrives at the sink, shower or other fixture where it is needed.

Case study describing solar thermal and photovoltaic systems in new construction.

Article Describing methods for thermally isolating multifamily parking garages.

The Builder's Guide provides the building industry with the latest and best practical information on how to apply building science principles to structures as systems in hot-humid climate regions.

Case study describing solar thermal and photovoltaic systems in new construction.

Case study describing solar thermal and photovoltaic systems in new construction.

Website with consumer and contractor information about building codes and regulations for solar water heating systems.

Website providing CAD files and drawings of advanced framing details.

Document outlining building science principles about air flow, heat flow and moisture flow in homes.

An article discussing how different metal roof materials and attachment methods affect the ability of the roof to thermally expand and contract and the durability of different solutions.

Report on the stability of furring strips as a means for cladding attachment over walls with thick exterior rigid insulation.

Research study investigating the energy performance and cost effectiveness of several state-of-the-art retrofit strategies that could be used in residential houses in the Boston and New England area.

Part I of the Guide addresses walls constructed with 2x6 wood frame studs, wood structural panel (WSP) sheathing as exterior sheathing, gypsum board as interior sheathing, and a cladding system installed over WSP sheathing in low-rise residential buildings up to three stories in height. Walls with...

The Guide addresses walls constructed with 2x4 wood frame studs, wood structural panel sheathing (WSP) as wall bracing and added backing for foam sheathing, a layer of rigid foam sheathing insulation up to 1.5 inches thick over the WSP, and a cladding system installed over the foam sheathing in low...

Part I of the Guide addresses walls constructed with 2x6 wood frame studs, wood structural panel (WSP) sheathing as exterior sheathing, gypsum board as interior sheathing, and a cladding system installed over WSP sheathing in low-rise residential buildings up to three stories in height.

Website providing building science based guidance and training for residential construction.

Article describing research encouraging use of exterior insulation to warm interior sheathing surfaces in walls and roof assemblies to reduce the likelihood of condensation during cold weather

Report focusing on building envelopes that have been enhanced with phase change materials (PCMs), which can simultaneously reduce total cooling loads and shift peak-hour loads.

Report describing the monitored long-term performance of two solar domestic water heating systems in northern climates.

Job Process sheet for the manufactured housing industry showing how to cut insulation batts to fit wall cavities in a factory production environment.

Guidance document on deep energy retrofits.

Website providing lists of WaterSense-qualified products for home plumbing and irrigation equipment that meet the requirements of the U.S. Environmental Protection Agency’s (EPA’s) WaterSense program.

Information about dense pack, cellulose insulation.

A quick guide from the California Division of the State Architect (DSA) explaining the three types of gas shutoff devices to stop the flow of natural gas into buildings in the event of an earthquake or rupture of the gas line.

The objective of this research was to quantify the field performance of wood-frame walls clad with a variety of common claddings in a mixed-humid climate.

Report on problems and solutions with EIFS stucco wall cladding systems.

Discussion of structural thermal resistance.

Website from the U.S. Department of Energy providing consumers with information on saving energy and using renewable energy technologies.

Information sheet with details on a building enclosure designed for Albuquerque, NM, as an example for building enclosures built for hot-dry and mixed-dry climates.

Information sheet that summarizes Insulated Concrete Form (ICF) construction including advantages and disadvantages of this construction strategy.

Report exploring feasibility of designing prescriptive retrofit measure packages for typical Chicago region multifamily buildings in order to achieve 25% source energy savings.

Documents describing Flood Resistant Provisions of the international codes (including the international building, residential, exiting building, mechanical, plumbing, fuel gas, fire, swimming pool and spa, private sewage disposal, and code council performance codes) and summaries of changes from the...

Factsheet describing backflow valve benefits and tips.

Report on the field evaluation of whole-building approaches and estimation of the relative contributions of select technologies toward reducing energy use related to space conditioning in new manufactured homes.

Research report assessing the moisture and cooling load impacts of airtightness and mechanical ventilation in homes in hot-humid climates.

Website with information for consumers about solar thermal systems for homes.

Website providing certifications and codes for automatic gas shut off valves in the state of California.

Brochure on specifications for solar thermal systems.

Document that gives a step-by-step approach for designing attachments for cladding materials through foam sheathing.