Library

California State Code of Regulations, Title 16, Division 8, Article 3, listing requirements for plumbing contractors.

Article describing correct ways to eliminate water damage by incorporating a sacrificial layer to foundation walls and footings.

Catalog describing FEMA earthquake-resistant construction resources.

Website of the Cold Climate Housing Research Center.

Information sheet with information about insulating and ventilating attics.

Website providing disaster preparedness information and resources for residents and building owners in locations susceptible to earthquakes.

Case study characterizing the framing factors for the exterior walls, ceilings, and floors of 180 wood-framed low-rise residential buildings across the United States.

Report identifying housing characteristics and energy use for fifteen single-family housing types and specifies measure packages that provide an optimum level of energy savings based on a BEopt analysis.

News article from SFGate explaining and giving figures on how chimney failure is the most common type of damage to homes during an earthquake.

Report on the stability of furring strips as a means for cladding attachment over walls with thick exterior rigid insulation.

Article describing correct ways to attach rigid insulation to the exterior of commercial and residential buildings.

Research study describing an experimental and theoretical investigation of the energy and hygrothermal performance of retrofit foundation insulation systems in climate zones 6 and 7.

Report on heating and cooling air-distribution ducts that are insulated, installed close to the ceiling in a vented attic and covered with attic insulation to minimize energy loss.

Information guide describing issues with concrete floors, in multiple climate zones.

Report covering insulating crawlspaces.

The Guide addresses walls constructed with 2x4 wood frame studs, wood structural panel sheathing (WSP) as wall bracing and added backing for foam sheathing, a layer of rigid foam sheathing insulation up to 1.5 inches thick over the WSP, and a cladding system installed over the foam sheathing in low...

Part I of the Guide addresses walls constructed with 2x6 wood frame studs, wood structural panel (WSP) sheathing as exterior sheathing, gypsum board as interior sheathing, and a cladding system installed over WSP sheathing in low-rise residential buildings up to three stories in height.

The Guide addresses walls constructed with 2x4 wood frame studs, wood structural panel (WSP) sheathing as wall bracing and added backing for foam sheathing, a layer of rigid foam sheathing insulation up to 1.5 in. thick over the WSP, and a cladding system installed over the foam sheathing in low...

Document presenting step-by-step process for installing rigid insulating sheathing over wood studs or house wrap.

Article describing research encouraging use of exterior insulation to warm interior sheathing surfaces in walls and roof assemblies to reduce the likelihood of condensation during cold weather

Research report anayzing the results of a large retrofit project, turining an old school into near zero energy consumption apartments in Greenfield MA.

Article describing the difference between conditioned or unvented attics and unconditioned or vented attics.

Research study examining the opportunities for cost-effective energy efficiency and renewable energy retrofits in residential archetypes constructed before 1980 (Pre-Code) in 14 U.S. cities.

Information sheet about crawlspace insulation, including installation details.

Article discussing whether or not to seal and insulate crawlspaces.

Job Process sheet for the manufactured housing industry showing how to cut insulation batts to fit wall cavities in a factory production environment.

Article describing the importance of air sealing, insulation, and roof ventilation in reducing the likelihood of ice dam formation on roofs in cold snowy climates.

Report covering exterior energy retrofits of masonry buildings.

FEMA risk management series guide on hospital safety and resilience to natural disasters.

Report explaining the principles of seismic design to architects.

Guide informing architects and engineers about designing buildings to be constructed with structural insulated panels.

Report identifying codes and standards that embody the concepts of resiliency.

Information about dense pack, cellulose insulation.

A quick guide from the California Division of the State Architect (DSA) explaining the three types of gas shutoff devices to stop the flow of natural gas into buildings in the event of an earthquake or rupture of the gas line.

Information sheet with HVAC duct insulation, testing, maintenance and performance information.

Designer checklist covering hazards involving ground and surface water, rain and water vapor, HVAC and plumbing, sunlight, insects, decay, and natural hazards, and builder checklist covering all disaster resistance, sorted by building component.

Case study describing foundation wall moisture studies at a research facility in Minnesota run by Building America team NorthernSTAR.

Factsheet describing how to secure refrigerators and other major appliances to wall studs using earthquake appliance straps or angle brackets and bolts.

Factsheet describing how to secure televisions, microwaves, computers, and other electronics to prevent damage during earthquakes.

Factsheet describing how to secure water heaters to resist seismic activity.

FEMA guide containing recommendations on how to implement cost-effective measures that can help to reduce the potential hazards associated with earthquakes.

Poster describing earthquake safety tips and protection measures to take at home.

A book describing how to complete an earthquake retrofit plan for wood-frame residential buildings.

Factsheet describing ways to retrofit a home to make it more earthquake resistant.

Webpage providing earthquake safety tips including proactive home structure and utility action items.

Guide provides homeowners ways to prepare for an earthquake and protect a home against earthquake damage.

Reference guide helping families prepare for an earthquake and prevent earthquake-related damage.

A one-page fact sheet outlining the purpose of an earthquake valve and how the valve can stop gas from flowing into a residence or building.

Standard providing minimum functionality requirements for earthquake-actuated automatic gas shutoff devices; applicable to systems carrying natural gas and propane, the devices are used in piping, equipment, and appliances typically found in structures of three stories or less.

Report providing an introduction to the NEHRP recommended seismic provisions for new buildings and other structures.