Library

Fact sheet describing how to install bracing to retrofit roof dormers for increased wind resistance.

A brochure educating homeowners on how to install self-locking devices on cabinets, drawers and doors, including child-proof latches and drawer locks.

Report identifying the steps to take, with the help of a qualified home performance contractor, to seal unwanted air leaks while ensuring healthy levels of ventilation and avoiding sources of indoor air pollution.

Report describing extensive renovations to a historic home.

Fact sheet describing proper roof sheathing installation and illustrating fastening methods that will enhance the durability of a building in high-wind areas; also published in FEMA P-499 “Home Builder’s Guide to Coastal Construction: Technical Fact Sheet Series.”

Factsheet from HUD describing how to properly rebuild following natural disasters in Puerto Rico.

Factsheet from HUD describing how homeowners can retrofit homes following natural disasters in the U.S. Virgin Islands.

Factsheet from HUD describing how to rebuild following natural disasters in Puerto Rico.

Factsheet for builders from HUD on how to rebuild homes following natural disasters in the U.S. Virgin Islands.

Report covering the planning, design, construction, and operation of residential and community safe rooms. Written for architects, engineers, building officials, local officials and emergency managers, and prospective safe room owners and operators.

Report promoting public safety and welfare by reducing the risk of earthquake-induced damage to existing homes.

Report promoting public safety and welfare by reducing the risk of earthquake-induced damage to existing homes.

Manual that identifies certain leakage limits for ducts and outlines procedures for testing ducts for conformity with air leakage limits that are set forth in a designer’s project specification.

Technical report providing site selection guidance for installation of small wind turbines.

Fact sheet describing field validations of a smart ventilation system to assess its effectiveness in assisting low-load homes in humid environments by maintaining acceptable indoor humidity conditions while ensuring adequate ventilation and indoor air quality.

Fact sheet outlining the research behind how smart ventilation controls boost energy efficiency and indoor air quality, including research findings from seasonal temperature, timer, and real-time weather-based controls showing that all three systems showed potential for energy savings while...

Initiatives of smoke-free housing policies in New York State.

Toolkits for residents and owner/managers who live and work in federally assisted housing.

Standard that defines the roles of and minimum requirements for mechanical and natural ventilation systems and the building envelope intended to provide acceptable indoor air quality in low-rise residential buildings; published in the year 2019, and is available for preview and purchase at the...

Standard that describes the minimum requirements for residential buildings to achieve acceptable indoor air quality via dwelling-unit ventilation, local mechanical exhaust, and source control. This version of the standard was published in the year 2022, and is available for preview and purchase at...

Standard 680 establishes definitions, classifications, test requirements, data requirements, ratings, operating requirements, marking and nameplate data and conformance conditions for residential air filter equipment.

Standard document establishing construction standards for one- and two-family dwellings constructed in high wind regions.

Standard describing methods for installing radon mitigation systems in existing residential buildings three stories or less in height which was published in the year 2021 and is available for preview and purchase at the reference link.

Detailed requirements for testing, exposure modeling, and allowable limits for modeled indoor air concentrations.

A website providing timely and accurate forecasts and watches for severe thunderstorms and tornadoes over the contiguous United States.

Report recommending strategies and approaches that the Federal government and other stakeholders may take to encourage and aid States and local communities in the adoption of the most current building codes.

Document targeting retrofit program managers, retrofit contractors, policy makers, academic researchers, and non-governmental organizations that work to realize energy savings from home energy upgrades (HEUs).

Article describing three ways to strengthen the roof-to-wall connections in an existing home.

Article defining structural design loads and ways to calculate them, including dead loads, live loads, soil lateral loads, wind loads, snow loads, earthquake loads, and other loads.

Recovery advisory presenting key wind retrofit guidelines for buildings located in hurricane-prone regions. These retrofit guidelines are intended to help building owners and designers prevent or limit wind damage and water infiltration during high-wind events.

Article describing suggested food supplies, sanitation, safety, and cooking for during and after an emergency.

Research project evaluating the pre-and post-retrofit energy consumption of a marine climate retrofit, compare actual energy use to original predictions, and identify opportunities for cost savings in other similar retrofits in this climate.

Presentation by the Washington University in St. Louis Office of Sustainability on saving energy.

A guide for homeowners on determining the risks from tornadoes and hurricanes and selecting a safe room type and location, as well as providing detailed plans for safe room construction.

Report presenting safe room designs and showing the homeowner and builder/contractor or local design professional how to construct a safe room for a home or small business.

Fact sheet providing the wind resistant provisions of the 2015 International Residential Code.

Presentation describing how to make a Corsi-Rosenthal Box for air cleaning.

Projectile missile testing of various wall panel configuration to understand how the different wall constructions would perform when struck with wind driven debris from a hurricane.

Article describing a field study that test ventilation performance in nine homes and found current ventilation was inadequate to remove PM2.5 and CO2 levels; however, a directly exhausting range hood can reduce peak PM2.5 concentrations by 75% or more.

Report illustrating CAD drawings and modeling of bracing layouts for a gable roof truss.

Report descrbing an early study pointing to the significant improvement, >50%, of a hip roof in reducing peak wind-induced pressures.

Manuals describing design, materials, and installation techniques applicable to almost all types of roof systems; four-volume set includes Metal Panel and SPF Roof Systems, Membrane Roof Systems, Architectural Metal Flashing and Condensation and Air Leakage Control, and Steep-Slope Roof Systems.

A book describing seismic retrofits to help contractors and engineers understand how to properly retrofit a home in a cost-effective manner.

Guide describing details that serve as a visual reference for each of the line items in the Thermal Enclosure System Rater Checklist.

Standard 55 specifies conditions for acceptable thermal environments and is intended for use in design, operation, and commissioning of buildings and other occupied spaces; is the current version of the standard, which was published in the year 2021, and is available for preview and purchase at the...

Blog article summarizing the effects of extreme heat on air quality and lung health.

Website providing guidance for people to find and use tools, information, and subject matter expertise to build climate resilience.

Information sheet providing definitions, applications, and techniques for applying air barriers.

Article describing the impact of increasingly stringent ventilation standards on multifamily buildings, highlighting the inefficiencies and challenges of exhaust-only ventilation in tightly sealed enclosures, the complications of achieving balanced ventilation, and the unintended consequences of...

This study uses a computer simulation approach to examine the energy and indoor air quality implications of passive and hybrid ventilation systems.