Library

Research report describing study of exterior retrofit approach for air sealing, insulating, and water management conducted by the NorthernSTAR Building America Partnership team run by University of Minnesota.

Case study describing the External Thermal and Moisture Management System developed by the NorthernSTAR Building America Partnership for retrofitting roofs with rigid foam over the roof deck, especially on one and a half-story homes.

Report addressing flood, wind and seismic hazards and recommends several multi-hazard resistant foundation designs of manufactured homes.

Fact sheet describing the special considerations that must be made when installing utility equipment, such as fuel, sewage, and water/sewage lines in a coastal home, and presenting recommendations for utility protection; also published in FEMA P-499 “Home Builder’s Guide to Coastal Construction...

Table calculating friction losses for PVC pipe by length.

Fact sheet describing design and construction practices to reduce the likelihood of water intrusion in walls and foundations in residential construction.

Document covering basic moisture control principles in the design of above-grade building enclosures; driving rain as a moisture load on walls; a classification system of the various rain control strategies available for walls; and good design practises for walls.

Report covering the performance of residential buildings during three hurricanes impacting Florida in 2004.

Document with important building science considerations, designed for members of the residential construction and remodeling industries, as well as owners and managers who work in affordable housing.

Report describing steps homeowners can take to improve the indoor air quality in their home, including ventilating, preventing pests, and reducing pollutants in the home.

Information sheet designed for the residential construction and remodeling industries, as well as owners and managers working in affordable housing. This sheet presents building guidance for both new construction and rehabilitation, as well as practices that can be used by property maintenance...

Report from FEMA on how to reduce damage from localized flooding including planning, drainage, building codes and retrofits, and regulations.

This study used an advanced airflow, energy and humidity modeling tool to evaluate the potential for residential mechanical pre-scooling strategies to reduce peak electriciy demand.

An EPA guide describing the causes and impacts of summertime urban heat islands, promoting strategies for lowering temperatures in U.S. communities.

Fact sheet describing best practices in installing leak-free refrigerant systems, including specifics on creating flare joints and brazed joints, pressure testing, vacuum testing, and charging the system with refrigerant.

Technical bulletin describing National Flood Insurance Program (NFIP) requirements for flood openings in foundation walls and walls of enclosures below elevated buildings.

Technical report describing the research and development of the Ventilation-Integrated Comfort System (VICS) which is a specifically designed, energy-efficient solution that seamlessly integrates with low-capacity, ducted heating, and cooling systems, offering controllable, balanced energy recovery...

Report describing information from DOE about rules and standards for residential air conditioners and heat pumps.

Webpage describing a DOE Cold Climate Heat Pump Challenge. The challenge engages industry partners and focuses around the Cold Climate Heat Pumps, a more environmental and efficient heating alternative to traditional heating.

Paper covering a parametric study of foundation heat exchanger-based ground source heat pump systems for several house configurations in a range of European locations, with an emphasis on determining feasible combinations.

Report discussing instrumentation methods and field operation characteristics of two GSHPs in test houses, including a comparison between the manufacturers listed COP values and the COPs calculated from field data.

Resource that differentiates products in the marketplace that meet WaterSense requirements.

Resource to help builders better understand the WaterSense requirements for labeled homes and assist them in meeting the criteria so they can receive the label for their new construction.

A quick-reference guide advising homeowners on how to elevate and protect outdoor HVAC equipment from high winds and floods.

Factsheet providing homeowners with an overview of approaches for flashing and sealing roof penetrations to help discussion with a roofing contractor.

Article describing how replacing permanent split capacitor (PSC) motors with electronically commutated motors (ECM) can boost bottom line for HVAC contractors as well as improve customer comfort and satisfaction.

Article from the Institute of Biological Engineering describing reverse osmosis water softeners.

Report describing how to construct a frost protected shallow foundation (FPSF) as a practical alternative to a deeper, more-costly foundation in cold regions with seasonal ground freezing and the potential for frost heave.

Web page providing an overview of room-level air conditioning systems such as window units and mini-splits.

Report from FEMA describing techniques for floodproofing structures.

A website providing information on how to properly size a water heater based on tank size, volume, peak hour demand and other factors.

How hard can it be to insulate a flat sheet of concrete? I mean you only have three choices – on the top, on the bottom, or on the edge. OK, you might have some combination of the three as well.

Manual that identifies certain leakage limits for ducts and outlines procedures for testing ducts for conformity with air leakage limits that are set forth in a designer’s project specification.

Report describing a comparison of hydrothermal performances of DryRightTM fiberglass batts and kraft-faced fiberglass batts in a south facing wall assembly with a moisture storage cladding material.

Fact sheet outlining the research behind how smart ventilation controls boost energy efficiency and indoor air quality, including research findings from seasonal temperature, timer, and real-time weather-based controls showing that all three systems showed potential for energy savings while...

Specification describing criteria for manufactured polymeric materials used to provide a rainscreen function, a means for the drainage of liquid moisture and the ventilation of vapor moisture that enters an above-grade exterior wall assembly which was published in the year 2019, and is available for...

Report about results of 10 test buildings in Chicago, studied to identify best practices for methodology, typical costs, and energy savings associated with steam system balancing.

Information sheet about buried ducts.

Document providing information on correct storage techniques for lumber to manage moisture.

Document describing correct construction of swales, designed to trap particulate pollutants (suspended solids and trace metals), promote infiltration, and reduce the flow velocity of storm water runoff.

Article describing ways to protect roofs from water infiltration by using self-adhering underlayment in vulnerable locations such as roof valleys, eave edges (to help deal with ice dams), rake edges, roofs to vertical walls (such as dormers), sidewall protection, the bottom of dormer valleys, and...

Report providing information based on research and case studies, to remodelers and consumers about opportunities to increase home energy performance.

Report describing the equipment selection of a split system air conditioner and furnace for an example house in Chicago, Illinois, as well as a heat pump system for an example house in Orlando, Florida.

Report about proper water heater selection developed to provide step-by-step procedures for evaluating preferred cost-effective options for energy efficient water heater alternatives based on local utility rates, climate, and anticipated loads.

Document describing issues of wind pressure resistance in walls with exterior rigid foam sheathing installed directly over framing members.

Research project evaluating the pre-and post-retrofit energy consumption of a marine climate retrofit, compare actual energy use to original predictions, and identify opportunities for cost savings in other similar retrofits in this climate.

Report providing performance results of a home's heat pump water heater and whole-house dehumidifier over a six-month period.

Document about laboratory testing of five integrated heat pump water heaters (HPWH).

Resource manual for builders, designers, architects, plumbers, and others interested in the WaterSense Labeled Homes Program providing an overview of the program, explains how to meet the program requirements, gives descriptions of water-saving technologies, and provides links to further resources.

Brochure with information about how to select and install house wrap and other weather-resistive barriers.