Library

Report describing two retrofit duct sealing techniques - manually-applied sealants and injecting a spray sealant, that were implemented in several low-rise multi-unit buildings in North Carolina.

Web report explaining how correct filter sizing is an issue that applies to all new and existing homes that use ducted HVAC systems.

Report outlining the issues with using existing ducts with a new low-load HVAC system, which reduces throw at supply registers causing decreased mixing of supply and room air, leading to potential thermal comfort complaints.

Report identifying two barriers that limit the ability of builders to explore opportunities for higher levels of energy efficiency in housing: the use of duct system materials that inherently achieve airtightness and are right-sized for low-load houses, and, the ability to air seal fire separation...

Research study describing experiments run in an unoccupied 1600 square foot house to evaluate the delivered performance as well as the relative performance of a SEER 21 variable capacity heat pump versus a SEER 13 heat pump.

Technical report describing the evaluation of four different ventilation strategies for providing make-up air in high-performance, new construction multifamily buildings in the Northeast, emphasizing the challenges posed by increasing airtightness standards and the variability of system performance...

Report describing research that helps inform best practices for air-sealing multifamily buildings in the Northeast.

Report summarizing the status of a central hydronic heating system project in multifamily housing at the conclusion of the 20112012 heating season.

The study described in this white paper is based on building energy modeling with an important focus on the indoor humidity impacts of ventilation.

Report providing step-by-step instructions for heating contractors and hydronic designers for selecting the proper control settings to maximize system performance and improve response time when using a thermostat setback.

This document addresses adding—or improving—mechanical ventilation systems to existing homes. The purpose of ventilation is to remove contaminants from homes either directly or by dilution. This report discusses where, when, and how much ventilation is appropriate in a home, including some...

Information sheet providing guidance about the placement of ventilation approaches.

Research project aimed to verify whether homes in the New Jersey HPwES program achieved 30% source energy savings, and if so, what measures were implemented to achieve them.

Report evaluating mechanical AC precooling strategies in homes as a method for improving the load factor by shifting cooling operation from on-peak to off-peak hours.