Library

Technical manual from ACCA outlining correct methods for zoning of residential HVAC systems.

This Standard establishes the minimum requirements to evaluate a residence with regards to energy efficiency, water conservation, occupant comfort, and indoor air quality.

Report describing two retrofit duct sealing techniques - manually-applied sealants and injecting a spray sealant, that were implemented in several low-rise multi-unit buildings in North Carolina.

Web report explaining how correct filter sizing is an issue that applies to all new and existing homes that use ducted HVAC systems.

Report outlining the issues with using existing ducts with a new low-load HVAC system, which reduces throw at supply registers causing decreased mixing of supply and room air, leading to potential thermal comfort complaints.

Report identifying two barriers that limit the ability of builders to explore opportunities for higher levels of energy efficiency in housing: the use of duct system materials that inherently achieve airtightness and are right-sized for low-load houses, and, the ability to air seal fire separation...

Website from the U.S. Department of Energy providing consumers with information on saving energy and using renewable energy technologies.

Research study describing experiments run in an unoccupied 1600 square foot house to evaluate the delivered performance as well as the relative performance of a SEER 21 variable capacity heat pump versus a SEER 13 heat pump.

Report detailing the effects of replacing PSC motors with more efficient, variable-speed motors.

Technical report describing the evaluation of four different ventilation strategies for providing make-up air in high-performance, new construction multifamily buildings in the Northeast, emphasizing the challenges posed by increasing airtightness standards and the variability of system performance...

Report describing research that helps inform best practices for air-sealing multifamily buildings in the Northeast.

Article describing RESNET guidance on evaporative coolers.

Report outlining how Smart ventilation controls (SVC) balance energy consumption, comfort, and IAQ by optimizing mechanical ventilation operation to reduce the heating and/or cooling loads, improve management of indoor moisture, and maintain IAQ equivalence according to ASHRAE 62.2.

Standards criteria supporting ICC HVAC duct support standards.

Report summarizing the status of a central hydronic heating system project in multifamily housing at the conclusion of the 20112012 heating season.

The study described in this white paper is based on building energy modeling with an important focus on the indoor humidity impacts of ventilation.

Report describing as-found interior platform return plenums, the magnitude of their contribution to the total amount of duct leakage, and techniques and results of retrofits executed by the HVAC trade during equipment replacement.

Report providing step-by-step instructions for heating contractors and hydronic designers for selecting the proper control settings to maximize system performance and improve response time when using a thermostat setback.

This document addresses adding—or improving—mechanical ventilation systems to existing homes. The purpose of ventilation is to remove contaminants from homes either directly or by dilution. This report discusses where, when, and how much ventilation is appropriate in a home, including some...

Standard that prescribes a testing method to determine the efficiency of space heating and/or cooling thermal distribution systems under seasonal and design conditions. This version of the standard was published in the year 2014, and is available for preview and purchase at the reference link. The...

Information sheet providing guidance about the placement of ventilation approaches.

Research project aimed to verify whether homes in the New Jersey HPwES program achieved 30% source energy savings, and if so, what measures were implemented to achieve them.

U.S. DOE report summarizing findings from literature and research relevant to HVAC installation practices.

Report evaluating mechanical AC precooling strategies in homes as a method for improving the load factor by shifting cooling operation from on-peak to off-peak hours.

Article describing how replacing permanent split capacitor (PSC) motors with electronically commutated motors (ECM) can boost bottom line for HVAC contractors as well as improve customer comfort and satisfaction.

Technical study exploring the impact of different installation faults on heat pump performance in a single-family house.

Study conducted to help determine cost-effective solutions for heating and cooling houses that are designed to be energy efficient.

Proposed HVAC filter labeling standard and underlying analysis by the California Energy Commission.

Standard describing methods for testing the airtightness of buildings and HVAC equipment.

Test method that measures the capture efficiency of wall-mounted domestic range hoods under controlled conditions in a test chambers which available for preview and purchase at the link and was published in the year 2018.

NAFA’s user guide for understanding ANSI/ASHRAE Standard 52.2-2012.