Library

2018 edition of code for commercial buildings that brings together all structural, plumbing, mechanical, fuel gas, energy and electrical provisions for all buildings except detached one- and two-family residences and townhouses up to three stories.

The manual covers residential zoning issues - multiple, single-zone, and central multi-zone systems - and includes advice on working with homeowners to adapt the heating or cooling system design to meet modern home design features.

The research report outlines a practical and cost-effective strategy utilizing central HVAC systems to optimize humidity control and ventilation in energy-efficient homes located in hot-humid climates, demonstrating significant improvements without requiring complex equipment upgrades.

Case study about high humidity, mold and condensation on surfaces in S. Florida, and how building characteristics cause and amplify these problems.

A publication highlighting recommendations that contribute to improved overall performance in the structural shell and focus on good connection details to tie together exterior walls, roofs and floors.

Information sheet offering general recommendations on supplemental humidity control and outlines viable system configurations.

Report describing a deep energy retrofit project for a two-family wood framed home located in Belmont, Massachusetts.

A list of EPA-certified wood-burning appliances for home heating for a range of budgets.

The Guide addresses walls constructed with 2x4 wood frame studs, wood structural panel (WSP) sheathing as wall bracing and added backing for foam sheathing, a layer of rigid foam sheathing insulation up to 1.5 in. thick over the WSP, and a cladding system installed over the foam sheathing in low...

Wildfire construction guidelines from the Colorado State Forest Service focusing on site design and building materials to mitigate damage to homes in wildfire-prone areas.

IRC guide referencing wood truss bracing best practices and requirements.

Report providing the results of an analysis of humidity control and variable refrigerant flow (VRF) system efficiency in three new multifamily buildings in New York, NY.

Report providing extensive guidance on controlling moisture in building envelopes through proper selection and installation on air, water, thermal, and vapor barriers.

Research study identifying the best performing, most energy-efficient and cost- effective techniques to provide controlled mechanical ventilation and humidity control in hot- humid climates with thermally efficient building envelopes.

Report informing building stakeholders about the risks a snow event poses to their buildings, preventative measures to take before the snow season, and actions that should be taken before, during, and after a snow event.

Report covering coating and back venting wood based claddings and trim.

Image depicting damage from termites in weatherboard cladding.

Fact sheet describing the results of an analysis of humidity control and variable refrigerant flow (VRF) system efficiency in three new multifamily buildings in New York, NY.

Building science report describing issues with vented attics in hot-humid climates and how sealed attic construction may be a solution.

Report providing design guidance for wood-framed residential construction in high wind areas where design wind velocity requirements do not exceed 140 miles per hour.