Library

Report about City of Meriden Housing Authority's (MHA) collaboration with Jonathon Rose Companies to complete a gut renovation of 126 residential units in the Chamberlain Heights retrofit project.

Report about the Advanced Envelope Research effort will provide factory homebuilders with urgently-needed, cost effective methods for meeting emerging energy code requirements.

Expert Meeting about interior insulation retrofit of mass masonry wall assemblies held on July 30, 2011.

Study characterizing how foundation heat exchangers (FHXs) used in residential ground source heat pump systems represent a potential cost savings due to their lesser first cost over other types of heat exchangers.

Research study evaluating the dynamic heat transmission characteristics through two identical Insulating Concrete Form (ICF) wall assemblies in Ottawa, Canada.

Journal article describing lessons learned from updating a 16-year-old deep-energy retrofit.

Research study presenting results of an existing home monitoring project designed to measure wall cavity moisture characteristics.

Report covering control of hydrostatic pressure in wall assemblies.

Document providing information on basement insulation, air sealing and water management retrofits.

Information sheet providing information on installing Rigid XPS foam board insulation to existing brick masonry walls.

Report summarizing the importance of properly insulating and air sealing masonry walls, providing step by step instructions and approaches.

Document providing renovators and retrofit contractors an overview of considerations when including wall air sealing and insulation in an energy retrofit project.

Report describing the work conducted for high performance hybrid assemblies.

Document about development of models for evaluating thermal performance of walls in existing homes that will improve the accuracy of building energy simulation tools when predicting potential energy savings of existing homes.

Report covering wind loading on roofing assemblies.

How hard can it be to insulate a flat sheet of concrete? I mean you only have three choices – on the top, on the bottom, or on the edge. OK, you might have some combination of the three as well.

Projectile missile testing of various wall panel configuration to understand how the different wall constructions would perform when struck with wind driven debris from a hurricane.

Presentation describing the challenges of insulating an existing basement, presented to the Building America residential energy-efficiency stakeholder meeting.

Report summarizing NRELs efforts to develop diagnostic test cases to conduct accurate energy simulations when phase change materials (PCMs) are modeled in residential buildings.

Report describing the design and construction of a highly energy efficient community of ten duplexes in Greenfield, Massachusetts.