Library

Article describing the principle of capillarity in construction materials.

Book describing Carpentry and Construction, Construction Materials, Hand Tools, Power Tools, Construction Equipment, Jobsite Safety, and Working Conditions, Building Design and Print reading, Inspections Survey Instruments and Operations, Foundation and Outdoor Slab Construction, Floor, Wall, and...

Design guide providing solutions and tools for designing central heat pump water heater systems in multifamily and other commercial buildings.

Document with information from a workshop addressing framing materials for residential buildings in California. A copy of the document can be requested at the resource link, and an online copy of the document can be found by searching for it on the California Energy Commission's Library Online...

Document providing guidance about choosing the correct caulk for a project.

Report on the stability of furring strips as a means for cladding attachment over walls with thick exterior rigid insulation.

Volume II of a two-volume report providing a comprehensive approach to design, construction, and renovation of homes located in coastal environments.

Document containing a 3D drawing (CAD) of advanced framing details.

Information sheet discussing the properties and benefits of insulating concrete forms.

Webpage with instructions for heat pump installers to choose the most suitable type of heat pump system, according to a project’s specific requirements.

Document for contractors detailing how to prioritize, control, and configure heat pumps in a residence that uses two heating systems.

Document for customers describing the benefits of two-system controls for homes, including information answering how, when, why, and how two-system controls with multiple heating sources are employed.

The Guide addresses walls constructed with 2x4 wood frame studs, wood structural panel sheathing (WSP) as wall bracing and added backing for foam sheathing, a layer of rigid foam sheathing insulation up to 1.5 inches thick over the WSP, and a cladding system installed over the foam sheathing in low...

The Guide addresses walls constructed with 2x4 wood frame studs, wood structural panel (WSP) sheathing as wall bracing and added backing for foam sheathing, a layer of rigid foam sheathing insulation up to 1.5 in. thick over the WSP, and a cladding system installed over the foam sheathing in low...

Research report anayzing the results of a large retrofit project, turining an old school into near zero energy consumption apartments in Greenfield MA.

Technical bulletin addressing surfacing options in regards to composite wood panels and their emission barrier capabilities.

Information sheet about crawlspace insulation, including installation details.

Webpage from FireSafe Marin explaining the different landscaping strategies near homes to lower the risk of a home's ignition from wildfire.

Fact sheet describing guidance for choosing appropriate materials and using proper construction practices when rebuilding, repairing, or renovating a home to increase its resistance to fires.

Standard describing prediction, mitigation, and reduction of moisture damage to the building envelope, materials, components, systems, and furnishings, depending on climate, construction type, and HVAC system operation; the webstore allows preview or full purchase.

Article describing the causes of wood decay and moisture issues.

Article from Stephen L. Quarles on fire resistant decking design and materials recommendations.

Part of a larger LBNL report (Deep Energy Retrofit Guidance for the Building America Solutions Center), the Design and Construction Process chapter provides detailed guidance for each process phase: pre-planning, planning, construction, test-out and post-occupancy.

Part of a larger LBNL report (Deep Energy Retrofit Guidance for the Building America Solutions Center), the Lessons Learned chapter focuses on successful deep energy retrofit projects throughout the U.S.

Part of a larger LBNL report (Deep Energy Retrofit Guidance for the Building America Solutions Center), the Occupant Behavior chapter discusses how to assess homeowner behavior patterns and use these patterns to enhance overall energy savings.

Part of a larger LBNL report (Deep Energy Retrofit Guidance for the Building America Solutions Center), the Over Time, Phased Guidance chapter presents a phased approach to deep energy retrofits.

Part of a larger LBNL report (Deep Energy Retrofit Guidance for the Building America Solutions Center), the Reducing costs and Increasing Cost-Effectiveness chapter provides suggestions for controlling deep retrofit costs, including both 'do's' and 'don'ts'.

This study focuses on the design, construction, and performance of the interior chase approach as implemented by five different builders in Texas, North Carolina, and Florida.

Guide describing design recommendations to ensure that electric vehicle charging stations comply with the Americans with Disabilities Act

Article from The Home Energy Community of Practice on designing energy efficient homes in hot climate zones, including home orientation, window location, and roof design considerations.

Wildfire resistant home checklist from Murray Milne, a professor of architecture at UCLA, who outlines seven steps to take to improve a home's chance of survival during a wildfire.

A guide on the use of rain barrels for greater water efficiency and use in gardens and lawns.

A research paper exploring the installation and mounting of solar photovoltaic (PV) panels on rooftops and the challenges faced by system designers and installers.

Website for the U.S. DOE Solar Decathlon competition.

Report covering the rainwater performance of building assemblies.

FEMA guide containing recommendations on how to implement cost-effective measures that can help to reduce the potential hazards associated with earthquakes.

Report on problems and solutions with EIFS stucco wall cladding systems.

Brochure providing information on the design of the EPA Region 8 headquarters in Denver, CO.

Guidance documents describing Erosion Control Blankets (ECBs) use as a construction material that provides temporary cover and support for establishing vegetation on bare soil. ECB holds topsoil and seed (typically grass) in place to minimize erosion during germination of seed.

Study investigating homeowner measure package choices in the Illinois Home Performance with ENERGY STAR program compared to cost-optimal choices determined through Building Energy Optimization (BEopt) modeling software.

Case study on exhaust ventilation and corresponding outdoor air intake strategies implemented in high-performance new-construction multifamily buildings.

Report about an experimental evaluation conducted on a night sky cooling system designed to substantially reduce space cooling needs in homes in North American climates.

An example of a commercially available thermally expansive fire stopping product for controlling the spread of fires in a rainscreen cavity.

A recovery advisory guide presenting important recommendations to reduce wind and water infiltration damage to new and existing residential buildings.

Summary document describing flood resistant building materials and some tips for building flood resistant walls.

Fact sheet discussing safe room and storm shelter door assemblies along with ICC® 500 compliance.

Article explaining what a continuous load path is and the key connection points that make it up.

Technical bulletin describing a set of standards for building materials able to withstand flood waters as needed with wet floodproofing.

Guide discussing the siting of residential and community safe rooms at appropriate elevations and locations.

Fact sheet discussing designs for prefabricated safe rooms built to ICC 500 standards mentioned in FEMA P-361.