Library

Report providing builders in the hot-dry and mixed-dry climates with guidance for building homes that have whole-house energy savings of 40% over the Building America benchmark with no added overall costs for consumers.

A guidebook helping builders in hot-humid climates design and construct homes for energy efficiency, durability, health, safety, and comfort.

Report describing measures that builders in mixed-humid climates can use to build homes that have whole-house energy savings of 40% over the Building America benchmark with no added overall costs for consumers.

Report describing an air distribution system composed of a series of uniformly-sized ducts that terminate in rooms throughout the home and return to a central manifold, similar in fashion to a “home-run” cross-linked polyethylene plumbing system.

Fact sheet poster describing how to add exterior, continuous, rigid insulation to the exterior walls when replacing siding on an existing home.

Document providing guideance and considerations for duct design in an energy efficient house.

Report that collected field data from a whole-home program in Illinois are utilized to compare marketplace-installed measures to the energy saving optimal packages previously developed for 15 housing types.

Report on adding insulation to load-bearing mass masonry buildings.

Report outlining workflow and results of regression models on monthly and daily utility data (meter readings of electricity consumption), outlining a process for screening and gathering useful results from inverse models.

Report about a building project in the marine climate.

Report focused on foundation insulation R-values for cold climates and the design, construction, and performance implications.

Report about a project that examines implementation of advanced retrofit measures in the context of a large-scale weatherization program and the archetypal Chicago, Illinois, brick bungalow.

This report outlines research activities that are expected to facilitate the adoption of energy retrofits by remodeling contractors and roofing contractors using retrofit panels which applicable to many existing house designs in most climates and markets.

Report summarizing commissioning, short-term testing, utility bill data analysis, and results of on-site monitoring of a deep energy retrofit.

Brochure explaining the essential basis for advanced framing and some of the more common advanced framing details.

Information sheet about insulating slabs.

Information sheet providing recommendations on the installation of vapor control layers.

Article describing selecting insulation for minimizing condensation risks.

Presentation about building highly efficient, affordable homes that will achieve 40% whole-house energy savings in mixed-humid climates.

Case study about Artistic Homes of Albuquerque, New Mexico, the first home builder in the United States to offer true net zero energy construction to the average home buyer on every home it builds.

Guide describing measures that builders in the cold and very cold climates can take to build homes that have whole-house energy savings of 40% over the Building America benchmark with no added overall costs for consumers.

Report summarizing research results for the 30% energy savings level and demonstrates that lead builders can successfully provide 30% homes in the Marine Climate Region on a cost-neutral basis.

This report will review, and summarize the current state of understanding and research into enclosures with higher thermal resistance, so-called “High-R Enclosures.” Recommendations are provided for further research.

Research study describing a number of promising foundation and basement insulation strategies that can meet the requirement for better thermal control in colder climates while enhancing moisture control, health, and comfort.

Document presenting some of the key technical properties of many of the most common building materials.

Guide informing builders and developers about efficient building practice for constructing homes with structural insulated panels.

Reference investigating the strategy of using buried and/or encapsulated ducts to reduce duct thermal losses in residential buildings.

Report describing a deep energy retrofit project for a two-family wood framed home located in Belmont, Massachusetts.

Design guide providing solutions and tools for designing central heat pump water heater systems in multifamily and other commercial buildings.

Report identifying housing characteristics and energy use for fifteen single-family housing types and specifies measure packages that provide an optimum level of energy savings based on a BEopt analysis.

Report on the stability of furring strips as a means for cladding attachment over walls with thick exterior rigid insulation.

Article describing correct ways to attach rigid insulation to the exterior of commercial and residential buildings.

Research study describing an experimental and theoretical investigation of the energy and hygrothermal performance of retrofit foundation insulation systems in climate zones 6 and 7.

Report on heating and cooling air-distribution ducts that are insulated, installed close to the ceiling in a vented attic and covered with attic insulation to minimize energy loss.

The Guide addresses walls constructed with 2x4 wood frame studs, wood structural panel sheathing (WSP) as wall bracing and added backing for foam sheathing, a layer of rigid foam sheathing insulation up to 1.5 inches thick over the WSP, and a cladding system installed over the foam sheathing in low...

Part I of the Guide addresses walls constructed with 2x6 wood frame studs, wood structural panel (WSP) sheathing as exterior sheathing, gypsum board as interior sheathing, and a cladding system installed over WSP sheathing in low-rise residential buildings up to three stories in height.

The Guide addresses walls constructed with 2x4 wood frame studs, wood structural panel (WSP) sheathing as wall bracing and added backing for foam sheathing, a layer of rigid foam sheathing insulation up to 1.5 in. thick over the WSP, and a cladding system installed over the foam sheathing in low...

Document presenting step-by-step process for installing rigid insulating sheathing over wood studs or house wrap.

Research report anayzing the results of a large retrofit project, turining an old school into near zero energy consumption apartments in Greenfield MA.

Research study examining the opportunities for cost-effective energy efficiency and renewable energy retrofits in residential archetypes constructed before 1980 (Pre-Code) in 14 U.S. cities.

Information sheet about crawlspace insulation, including installation details.

Job Process sheet for the manufactured housing industry showing how to cut insulation batts to fit wall cavities in a factory production environment.

Part of a larger LBNL report (Deep Energy Retrofit Guidance for the Building America Solutions Center), the Design and Construction Process chapter provides detailed guidance for each process phase: pre-planning, planning, construction, test-out and post-occupancy.

Part of a larger LBNL report (Deep Energy Retrofit Guidance for the Building America Solutions Center), the Lessons Learned chapter focuses on successful deep energy retrofit projects throughout the U.S.

Part of a larger LBNL report (Deep Energy Retrofit Guidance for the Building America Solutions Center), the Occupant Behavior chapter discusses how to assess homeowner behavior patterns and use these patterns to enhance overall energy savings.

Part of a larger LBNL report (Deep Energy Retrofit Guidance for the Building America Solutions Center), the Over Time, Phased Guidance chapter presents a phased approach to deep energy retrofits.

Part of a larger LBNL report (Deep Energy Retrofit Guidance for the Building America Solutions Center), the Reducing costs and Increasing Cost-Effectiveness chapter provides suggestions for controlling deep retrofit costs, including both 'do's' and 'don'ts'.

Case study describing foundation wall moisture studies at a research facility in Minnesota run by Building America team NorthernSTAR.

Report outlining the steps of translating a new home construction scope of work (SOW) to SOW for retrofit.

Document providing descriptions of the many insulation options available to homeowners, along with guidance on where, when, and how to install insulation throughout your house.