Library

2015 edition of code establishing minimum regulations for mechanical systems, including heating, cooling, ventilation, exhaust, ducts, fireplaces, combustion and hydronic systems, using prescriptive and performance-related provisions.

2018 edition of code for commercial buildings that brings together all structural, plumbing, mechanical, fuel gas, energy and electrical provisions for all buildings except detached one- and two-family residences and townhouses up to three stories.

A publication highlighting recommendations that contribute to improved overall performance in the structural shell and focus on good connection details to tie together exterior walls, roofs and floors.

Report describing a deep energy retrofit project for a two-family wood framed home located in Belmont, Massachusetts.

A list of EPA-certified wood-burning appliances for home heating for a range of budgets.

The Guide addresses walls constructed with 2x4 wood frame studs, wood structural panel (WSP) sheathing as wall bracing and added backing for foam sheathing, a layer of rigid foam sheathing insulation up to 1.5 in. thick over the WSP, and a cladding system installed over the foam sheathing in low...

A report describing six mechanical ventilation strategies that were evaluated for their ability to control indoor humidity levels over 14-day periods with simulated occupancy.

This report evaluates the performance of variable-capacity comfort systems, with a focus on inverter-driven, variable-capacity systems, as well as proposed system enhancements.

Wildfire construction guidelines from the Colorado State Forest Service focusing on site design and building materials to mitigate damage to homes in wildfire-prone areas.

IRC guide referencing wood truss bracing best practices and requirements.

Report providing the results of an analysis of humidity control and variable refrigerant flow (VRF) system efficiency in three new multifamily buildings in New York, NY.

Fact Sheet describing the need for supplemental dehumidification, dehumidifier configuration options, and design considerations.

Report describing solutions for supplemental dehumidification in warm-humid climates.

Report providing extensive guidance on controlling moisture in building envelopes through proper selection and installation on air, water, thermal, and vapor barriers.

Report informing building stakeholders about the risks a snow event poses to their buildings, preventative measures to take before the snow season, and actions that should be taken before, during, and after a snow event.

Report covering coating and back venting wood based claddings and trim.

Image depicting damage from termites in weatherboard cladding.

Fact sheet describing the results of an analysis of humidity control and variable refrigerant flow (VRF) system efficiency in three new multifamily buildings in New York, NY.

Preliminary results of two monitored lab homes constructed to represent the thermal characteristics of typical existing Florida homes are presented.

This report describes how twenty homes were tested and monitored in the Zone 2 climate of Houston, Texas, U.S.A., to evaluate the humidity control performance and operating cost of six different integrated dehumidification and ventilation systems that could be applied by production homebuilders.

Report providing design guidance for wood-framed residential construction in high wind areas where design wind velocity requirements do not exceed 140 miles per hour.