Library

2009 edition of code for commercial buildings that brings together all structural, plumbing, mechanical, fuel gas, energy and electrical provisions for all buildings except detached one- and two-family residences and townhouses up to three stories.

2009 edition of code establishing a baseline for the design and installation of fuel gas systems and gas fired appliances through performance requirements.

2009 edition of code for residential buildings that creates minimum regulations for one- and two-family dwellings of three stories or less, bringing together all building, plumbing, mechanical, fuel gas, energy and electrical provisions for one- and two-family residences.

2009 edition of code for commercial buildings that brings together all structural, plumbing, mechanical, fuel gas, energy and electrical provisions for all buildings except detached one- and two-family residences and townhouses up to three stories.

2012 edition of code for residential buildings that creates minimum regulations for one- and two-family dwellings of three stories or less, bringing together all building, plumbing, mechanical, fuel gas, energy and electrical provisions for one- and two-family residences.

Florida building code including all the amendments and additions by Florida for the wind-borne debris regions and the high-velocity hurricane zone.

Document describing portions of the flood provisions from the 2018 editions of the IBC, IRC, IEBC, IMC, IPC, IFGC, IFC, ISPSC, IPSDC, and ICC Performance Code.

Standard providing a methodology for calculating Energy Rating Index for code compliance.

Standard providing master specifications for closed cell, medium density spray polyurethane foam air barriers located in the non-accessible part of the wall.

Standard providing information about self-adhered sheet air barriers located in the non-accessible part of the wall and materials to bridge and seal air leakage pathways and gaps.

Standard providing nationally recognized, manufacturer-endorsed set of inspection tasks for HVAC maintenance.

Code establishing the rules of safety relating only to pressure integrity for the design, fabrication, and inspection of boilers and pressure vessels during construction which was published in the year 2017 and is available to order at the referenced link.

Webinar answering code-related questions on duct leakage tests, moisture levels in attics and crawlspaces, combustion equipment in conditioned attics, ventilation in multifamily buildings, and continuous insulation in residential construction.

2019 version of California's plumbing code.

Website of the Cold Climate Housing Research Center.

Part I of the Guide addresses walls constructed with 2x6 wood frame studs, wood structural panel (WSP) sheathing as exterior sheathing, gypsum board as interior sheathing, and a cladding system installed over WSP sheathing in low-rise residential buildings up to three stories in height. Walls with...

Checklist for the DOE Zero Energy Ready Home National Program Requirements Mandatory Requirement 7 (Renewable Ready).

A recovery advisory guide presenting important recommendations to reduce wind and water infiltration damage to new and existing residential buildings.

Article describing the history and the current debate about how to adjust the Florida building codes.

Standard that applies to storage water heaters, instantaneous water heaters, and circulating water heaters including booster water heaters; the current version of this standard was published in the year 2019 and it is available for purchase along with a digital preview on the ANSI webstore page.

Website article touring areas hit hardest by tornadoes to see how they are building differently to protect against the next big twister.

Standard using deficiency-based and systematic procedures that use performance-based principles to evaluate and retrofit existing buildings to withstand the effects of earthquakes. The current version of this standard was published in the year 2017, and is available in both digital and print...

Factsheet describing the use of rigid foam insulation to meet energy efficiency requirements and minimize fire risks.

Website providing a link for purchasing NFPA 1141, Standard for Fire Protection Infrastructure for Land Development in Wildland, Rural, and Suburban Areas.

Standard 680 establishes definitions, classifications, test requirements, data requirements, ratings, operating requirements, marking and nameplate data and conformance conditions for residential air filter equipment.

Standard describing a test method measuring air-leakage rates through a building envelope under controlled pressurization and de-pressurization which was published in the year 2019 and is available for preview and purchase at the reference link.

The 2017 publication update to the SEAOC Wind Committee and SEAOC Solar Photovoltaic Systems Sub-Committee's 2012 report.

Fact sheet describing best practices for flashing doors and windows to minimize air and water intrusion.

Document with information on preventing termites when using ICFs.

Fact sheet providing the wind resistant provisions of the 2015 International Residential Code.