Library

Part I of the Guide addresses walls constructed with 2x6 wood frame studs, wood structural panel (WSP) sheathing as exterior sheathing, gypsum board as interior sheathing, and a cladding system installed over WSP sheathing in low-rise residential buildings up to three stories in height. Walls with...

The Guide addresses walls constructed with 2x4 wood frame studs, wood structural panel sheathing (WSP) as wall bracing and added backing for foam sheathing, a layer of rigid foam sheathing insulation up to 1.5 inches thick over the WSP, and a cladding system installed over the foam sheathing in low...

Part I of the Guide addresses walls constructed with 2x6 wood frame studs, wood structural panel (WSP) sheathing as exterior sheathing, gypsum board as interior sheathing, and a cladding system installed over WSP sheathing in low-rise residential buildings up to three stories in height.

Website providing building science based guidance and training for residential construction.

The Consumer Product Safety Commission (CPSC) requirement for clothing storage units (CSUs) to be tested for stability, exceed minimum stability requirements, be marked and labeled with safety information, and bear a hang tag providing performance and technical data about the stability of the CSU.

Article describing research encouraging use of exterior insulation to warm interior sheathing surfaces in walls and roof assemblies to reduce the likelihood of condensation during cold weather

Standard covering requirements for the assembly, installation, maintenance, and operation of controls and safety devices on automatically operated boilers directly fired with gas, oil, gas-oil, or electricity, having fuel input ratings under 12,500,000 Btu/hr.

Report focusing on building envelopes that have been enhanced with phase change materials (PCMs), which can simultaneously reduce total cooling loads and shift peak-hour loads.

Report describing the analytical study of renewable energy retrofits to homes built before 1980 and whether it is cost efficient or not.

Technical bulletin addressing surfacing options in regards to composite wood panels and their emission barrier capabilities.

Standard describing prediction, mitigation, and reduction of moisture damage to the building envelope, materials, components, systems, and furnishings, depending on climate, construction type, and HVAC system operation; the webstore allows preview or full purchase.

Job Process sheet for the manufactured housing industry showing how to cut insulation batts to fit wall cavities in a factory production environment.

A presentation describing the details of the ENERGY STAR Multifamily New Construction program requirements.

Guidance document on deep energy retrofits.

Report explaining the principles of seismic design to architects.

Report identifying codes and standards that embody the concepts of resiliency.

Website providing information on U.S. residential and commercial building codes including adoption status.

Website listing implementation timelines and links to various versions of the DOE Zero Energy Ready Home national program requirements.

Homepage for DOE's Zero Energy Ready Homes program.

Checklist for the DOE Zero Energy Ready Home National Program Requirements Mandatory Requirement 7 (Renewable Ready).

Fact sheet poster describing benefits and qualification of U.S. Department of Energy (DOE) certified Zero Energy Ready Homes and providing eight examples of certified homes.

Information about dense pack, cellulose insulation.

A quick guide from the California Division of the State Architect (DSA) explaining the three types of gas shutoff devices to stop the flow of natural gas into buildings in the event of an earthquake or rupture of the gas line.

Report identifying two barriers that limit the ability of builders to explore opportunities for higher levels of energy efficiency in housing: the use of duct system materials that inherently achieve airtightness and are right-sized for low-load houses, and, the ability to air seal fire separation...

FEMA guide containing recommendations on how to implement cost-effective measures that can help to reduce the potential hazards associated with earthquakes.

Standard providing minimum functionality requirements for earthquake-actuated automatic gas shutoff devices; applicable to systems carrying natural gas and propane, the devices are used in piping, equipment, and appliances typically found in structures of three stories or less.

Webpage providing information on using awnings to enhance outdoor living space.

Presentation describing the history of ECM motors, an overview of ECM motor technology, and a lesson on the installation of ECM motors.

Free online tool for sizing central heat pump water heater systems.

The objective of this research was to quantify the field performance of wood-frame walls clad with a variety of common claddings in a mixed-humid climate.

Website to support the state of Vermont transition to a more affordable and cleaner future by affiliate with partners throughout Vermont to save customers money, strengthen our state’s economy, and lower carbon emissions.

Report on problems and solutions with EIFS stucco wall cladding systems.

U.S. Code of Federal Regulations energy and water conservation standards for consumer products including home appliances and HVAC equipment.

Website describing analyses for products and standards affecting home heating, cooling, and appliances, in regards to technical, economical, and energy efficiency pathways.

Discussion of structural thermal resistance.

Website from the U.S. Department of Energy providing consumers with information on saving energy and using renewable energy technologies.

A standard providing minimum energy efficiency requirements for buildings that are not low-rise residential buildings.

A standard providing minimum energy efficiency requirements for buildings that are not low-rise residential buildings.

A standard providing minimum energy efficiency requirements for buildings that are not low-rise residential buildings.

Website providing a listing of ENERGY STAR certified interior and exterior storm windows

ENERGY STAR website outlining the program requirements for NextGen, an EPA initiative aimed at advancing energy efficiency in residential construction.

Webpage for finding all the information you need to start shopping for ENERGY STAR certified products, including product details, rebates, and retailers near you.

Website showing compliance timelines for various versions of the ENERGY STAR Single-Family New Home program requirements with links to national program requirements documents and checklists.

Program criteria for residential exhaust fans used for ventilation.

Manual describing energy efficient building, design, and marketing strategies for Florida home builders.

Homepage for NREL research, support, and deployment information for the safety and health of workers, visitors, the public, the environment, and laboratory assets.

Handbook to help property owners understand the rules, procedures, standards, and criteria that apply to the environmental resource permit (ERP) program under Part IV of Chapter 373 of the Florida Statutes.

Section 608 establishes EPA’s National Recycling and Emission Reduction Program designed to reduce emissions related to maintaining, servicing, repairing, and disposing of air conditioning or refrigeration equipment.

Information sheet with details on a building enclosure designed for Albuquerque, NM, as an example for building enclosures built for hot-dry and mixed-dry climates.

Information sheet that summarizes Insulated Concrete Form (ICF) construction including advantages and disadvantages of this construction strategy.